Ask Civil Engineering Expert

My recollection may be skewed, so for our purposes, consider this example a hypothetical, but this is my recollection of a real case. In the early 80s, in Salt Lake County, Utah, a dispute arose involving the "largest open-pit copper mine" in the Western hemisphere, run by Kennecott Copper Corporation. Kennecott had recently been acquired by Beatrice, a conglomerate of many diversified interests. The collective bargaining agreement between Kennecott and its employees at the mine and smelter was nearing its end date. Negotiations were under way for a new agreement. The United Mine Workers union handled the negotiations on behalf of labor, with national representatives flying in to do so. The talks turned ugly. Neither side would budge. Management stood fast that given the economic climate and their financial condition, hourly wage increases requested were impossible. Union workers were averaging wages in the $25 to $30 dollar range already, and there was no way profit was possible at that rate. The mine would have to be shut down rather than giving in to such demands.

The UMW did not budge. The national scope and interest of other geographic areas was at stake. If the union gave in here, what would the ripple effect be in the North, South, and East? Literally, there was an impasse.

Beatrice made an executive decision. Negotiations were cut off. The mine was closed. The result was that 2,000 workers, on the upper end of the local labor demographic were laid off. Some were able to move to other areas of the country and find work, but most were not. The entire local economy was affected. Workers now had to find work for which they were unskilled, and at a low wage, minimum or just above. According to union rules, the mine had to remain closed for a three-year period, or the labor force must be unionized again. Beatrice did that. They used the hiatus to re-engineer the mine, automated the equipment and operation at the cost of millions of dollars, and opened the mine after the required down time. From then until now, with a labor force of under 600 non-union workers working at medium-level wages, Kennecott has operated a successful "for profit" operation, competing with international companies world wide.

Although this introduction is long, the questions to which I would like comment are,

1. "Who, if anyone, do you think did the right thing, and why?"

2. "Do you think the government (NLRB or another) should have intervened and forced an agreement?"

Civil Engineering, Engineering

  • Category:- Civil Engineering
  • Reference No.:- M9433264

Have any Question?


Related Questions in Civil Engineering

Assignment -ewb design report format - cover page - the as

Assignment - EWB Design Report Format - Cover page - The as EWB project Table of content Introduction about -EWB and CRDT (Cambodian Rural development team) Background about Cambodia - Economic, Weather, People - living ...

Assessment taskpractical investigationinstructions- it is

Assessment Task Practical Investigation Instructions: - It is very important that you read these instructions. - The hardcopy of the Assignment report, with the Assignment cover sheet, should be submitted to the Assignme ...

Task details the client is doing masters in civil

Task Details: The client is doing Masters in Civil Engineering. He needs a Technical Paper on Earthquake pertaining to Geology and Rock Mechanics. There should be a through discussion of Earthquake in relation to the men ...

Aimthis assignment aims to demonstrate the structural

Aim: This assignment aims to demonstrate the structural design requirements of a glazed façade in a multi-storey building. Among other requirements, the glazed façade is required to comply with Australian Standard AS 204 ...

Masonry design assignmentquestion 1 - derivation of seismic

MASONRY DESIGN ASSIGNMENT Question 1 - Derivation of seismic actions on building a) Determine the storey seismic weights (Wi) for each suspended level of the building, hence the seismic weight (Wt) of the entire building ...

Masonry design assignmentquestion 1 - derivation of seismic

MASONRY DESIGN ASSIGNMENT Question 1 - Derivation of seismic actions on building a) Determine the storey seismic weights (Wi) for each suspended level of the building, hence the seismic weight (Wt) of the entire building ...

Aimthis assignment aims to demonstrate the structural

Aim: This assignment aims to demonstrate the structural design requirements of a glazed façade in a multi-storey building. Among other requirements, the glazed façade is required to comply with Australian Standard AS 204 ...

Assignmenta continuous three spans beam with

Assignment A continuous three spans beam with centre-to-centre distance of 6 m supports 150 mm thick one-way slabs as shown below. The beams have clear spans of 8 m, 9 m, and 8 (face-to-face of 400 mm square columns). Th ...

The drainage system of a cantilever wall shown in below

The drainage system of a cantilever wall shown in below figure, became blocked after a heavy rainstorm and the groundwater level, which was originallybelow the base, rose to1.5 (m) below the surface. Determine the stabil ...

Civilyou are provided with bill of quantities prepared

Civil You are provided with bill of quantities prepared separately, priced and submitted by 3 con- tractors (A,B,C found on LMS) in respect of a proposed project (see appendix for drawings). The site is located on Mt. Al ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As