Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe differences between CRT and LCD.

2) Describe what LCD matrix types are.

3) Discuss the block diagram of VAC.

4) Describe some of the features of CRT.

5) Discuss some of the characteristics of the LCD.

6) Discuss structure and working of LED with the help of suitable diagram.

7) Describe some of the benefits of LCD over the CRT.

8) Describe what is capacitive and Hall effect switch.

9) Discuss the opto-electronics and membrane switch.

10) Describe the construction and working of the mechanical mouse.

11) Discuss the construction and working of the opto- mechanical mouse.

12) Describe the installation process of the mouse.

13) Describe the construction and working of the flatbed scanner.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911766

Have any Question? 


Related Questions in Electrical & Electronics

1 why is a circle with its center at the center of the

1. Why is a circle with its center at the center of the Smith Chart known as a constant SWR circle? Where on the circle is the corresponding SWR value marked? 2. Using the Smith Chart, how do you find the normalized line ...

1 state gauss law for the electric field2 how is volume

1. State Gauss' law for the electric field. 2. How is volume charge density defined? 3. State the law of conservation of charge. 4. How is Gauss' law for the electric field derived from Ampere's circuital law?

1 learning outcomesat the end of this project students will

1. Learning outcomes At the end of this project, students will be able to: 1) Analyze power system faults based on balance and unbalanced faults techniques. (PLO4-CTPS-C4) 2) Express power flow analysis using EMTP softwa ...

1 considering te modes in a dielectric slab guide specify

1. Considering TE modes in a dielectric slab guide, specify the fundamental mode and discuss the associated cutoff condition. 2. Compare the phenomenon at cutoff in a metallic waveguide with that at cutoff in an optical ...

1 what is the permittivity of free space what are its

1. What is the permittivity of free space? What are its units? 2. Describe the electric field due to a point charge. 3. How do you find the electric field intensity due to a continuous charge distribution? 4. How is curr ...

Figure 319 in the text shows that des creates 16 different

Figure 31.9 in the text shows that DES creates 16 different 48-bit keys, one for each round. Why do we need 16 different keys? Why can't we use the same key in each round?

In a real-time multimedia communication assume we have one

In a real-time multimedia communication, assume we have one sender and ten receivers. If the sender is sending multimedia data at 1 Mbps, how many RTCP packets can be sent by the sender and each receiver in a second? Ass ...

1 energy calculationsbuilding sf 20000 sfelectric rateuse

1. Energy Calculations Building SF = 20,000 sf Electric Rate: Use MTSU Utility Rate Schedule - Seasonal Rates Lighting: 2 watts/sf hours of operation = 19 hours per day Motors: One water pump motor, 80% efficient, runnin ...

State with reasons whether the following signals are

State with reasons whether the following signals are periodic or aperiodic. For periodic signals, find the period and state which of the harmonics are present in the series.

A module with 40 cells has an idealized rectangular i-v

A module with 40 cells has an idealized, rectangular I-V curve with I SC = 4 A and V OC = 20 V. If a single cell has a parallel resistance of 5Ω and negligible series resistance, draw the I-V curve if one cell is complet ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro