Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

Answer the following problems.

problem 1) prepare down the different advantages of fiber optical communication system.

problem 2) Compute the carrier frequency for an optical communication system operating at 1310 nm.

problem 3) Differentiate between RZ and NRZ modulation format.

problem 4) prepare down the difference between loose and tight buffer fibers in terms of operation?

problem 5) How light radiation occurs in a p-n junction semiconductor?

problem 6) What do you mean by carrier lifetime of charge carriers in photo detectors

problem 7) Describe red and blue shift in optical communication systems.

problem 8) What do you mean by speckle noise?

problem 9) Why mode partitioning noise is dominant in single mode fibers?

problem 10) describe the statement, "Optical & electrical noises are different" in detail.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M98440

Have any Question? 


Related Questions in Electrical & Electronics

A current distribution is given bywhere j0 is a constant

A current distribution is given by where J 0 is a constant. Using Ampere's circuital law in differential form and symmetry considerations, find the magnetic field everywhere.

1 describe the phenomenon of the bouncing back and forth of

1. Describe the phenomenon of the bouncing back and forth of transient waves on a transmission line excited by a constant voltage source in series with internal resistance and terminated by a resistance. 2. Discuss the v ...

The strain energy and work done by applied loads are given

The strain energy and work done by applied loads are given in the following equations. When the solution is expressed by u(x) = c 1 x + c 2 x 2 , calculate the solution using the principle of minimum potential energy.

A voltage generator is connected to the input of a lossless

A voltage generator is connected to the input of a lossless line short-circuited at the far end. The frequency of the generator is varied and the line voltage and line current at the input terminals are monitored. It is ...

1 two point charges each of mass m and charge q are

1. Two point charges each of mass m and charge q are suspended by strings of length l from a common point. Find the value of q for which the angle made by the strings at the common point is 90°. 2. Point charges Q and ar ...

Load flow calculation -in the power network shown below

Load Flow Calculation - In the power network shown below, node 1 is the slack bus, where the nodal voltage is defined as (1.0∠0 o ) pu, nodes 2, 4 and 5 are load buses, and node 3 is a generator bus where the voltage mag ...

Determine if the filters with the following transfer

Determine if the filters with the following transfer functions are physically realizable. If they are not realizable, explain if and how they can be approximately realized. Be as specific as possible. (c) H(ω)=2πδ(ω)

Assuming the x- and y-axes to be directed eastward and

Assuming the x- and y-axes to be directed eastward and northward, respectively, find the expression for the propagation vector of a uniform plane wave of frequency 15 MHz in free space propagating in the direction 30° no ...

Below is the governing differential equation of

Below is the governing differential equation of one-dimensional bar under uniformly distributed load. Using one bar element, calculate the displacement at x = L and x = 1/2L. Compare these displacements with that of the ...

A sinusoid cosomega0t is a bandpass signal with zero

A sinusoid cos(ω0t) is a bandpass signal with zero bandwidth. This implies that the sampling rate that will allow reconstruction of this signal from its samples can be arbitrarily small. Show that this is indeed the case ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro