Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

Answer the following problems.

problem 1) Describe the transponder, forward link and reverse link.

problem 2) prepare down the advantages and disadvantages of non-linear amplifier.

problem 3) prepare down the differences between active and passive satellites?

problem 4) If the data is to be carried to 5000 kM whether optical fiber or satellite is preferred for communication?

problem 5) describe the effect of orbital inclination.

problem 6) Describe the concept of frequency hopping.

problem 7) What parameters are to be considered for the design of downlink. State the parameters only.

problem 8) What are interference effects on complete link design equation?

problem 9) What do you understand by channel throughput? What is its importance?

problem 10) What do you understand by noise figure? What is its significance?

problem 11)(a) prepare down the advantages of CDMA over TDMA and FDMA.

(b) How satellite switched TDMA helps to preserve network synchronization?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M98495

Have any Question? 


Related Questions in Electrical & Electronics

1 repeat the previous problem without the assumption that

1. Repeat the previous problem without the assumption that the velocity in the heating section is negligible. The ratio of the flow area of the heating section to the chimney flow area is R. 2. Consider a 4-cm pipe that ...

An estimate is needed on the lift provided by a hydrofoil

An estimate is needed on the lift provided by a hydrofoil wing section when it moves through water at 60 mph. Test data are available for this purpose from experiments in a pressurized wind tunnel with an airfoil section ...

1 what is the direction of the magnetic field for a uniform

1. What is the direction of the magnetic field for a uniform plane wave having its electric field in the positive z-direction and propagating in the positive x-direction? 2. What is intrinsic impedance? What is its value ...

1 what is the total distance around the circumference of a

1. What is the total distance around the circumference of a circle of radius 1 m? What is the total vector distance around the circle? 2. What is the total surface area of a cube of sides 1 m? Assuming the normals to the ...

1 implement the 2-to-4 decoder using 7404 not an 7808 and

1. Implement the 2-to-4 decoder using 7404 (NOT) an 7808 (AND) chips on your breadboard. 2. Implement the 2-to-4 decoder circuit with a 74139 chip on your breadboard. 3. Implement a 1-to-2 decoder in Logisim. Implement t ...

Identify the variables associated with given problem and

Identify the variables associated with given Problem and find the dimensionless parameters. Problem The device in the schematic diagram below is a viscosity pump. It consists of a rotating drum inside of a stationary cas ...

Determine the spacing relative amplitudes and phase angles

Determine the spacing, relative amplitudes, and phase angles of current densities for an array of two infinite plane parallel current sheets required to obtain a radiation characteristic such that the field radiated to o ...

Assignmentpart 1 electricians tools1 which of the following

Assignment Part 1: Electricians' Tools 1. Which of the following types of symbols would be used on an electrical drawing for a large machine? A. Schematic symbols B. Blueprint symbols C. Pictorial symbols D. Wiring symbo ...

1 is it meaningful to consider two different surfaces

1. Is it meaningful to consider two different surfaces bounded by a closed path to computethe two different currents on the right side of Ampere's circuital law to find around the closed path? 2. Discuss briefly the appl ...

1 briefly outline the procedure involved in the successive

1. Briefly outline the procedure involved in the successive solution of Maxwell's equations. 2. How does the technique of successive solution of Maxwell's equations reveal the interaction between the electric and magneti ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro