Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Describe the theory of graded index fiber and deduce the numerical aperture of the graded index fiber.

2)  Describe the following term:

a) Mode theory

b) Ray theory.

3) Describe the several optic fiber losses.

4) Describe about the following

a) Different fabrication methods of fiber optic.

b) Pulse broadening

5) Describe the principle working of the LASER diode. describe the effect on the performance of LASER due to the temperature.

6) describe about the following term:

a) Avalanche photo diode

b) PIN photo diode.

7) Describe the link budget analysis of the point to point optical link and deduce the necessary equation for that.

8) describe the following term:

a) Splicing loss measurement

b) Lensing schemes for coupling improvement

9) Describe the operation of the optical receiver and performance calculation of it.

10) Describe the design methodology for the analog receiver with required flow chart.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M912979

Have any Question? 


Related Questions in Electrical & Electronics

Below is the governing differential equation of

Below is the governing differential equation of one-dimensional bar under uniformly distributed load. Using one bar element, calculate the displacement at x = L and x = 1/2L. Compare these displacements with that of the ...

Consider a deformation of a rectangular bar whose deformed

Consider a deformation of a rectangular bar whose deformed geometry is given as x 1 = αX 1 , x 2 = βX 2 , x 3 = βX 3 When the material is an incompressible Mooney-Rivlin hyperelastic material with A 10  = 80 MPa and A 01 ...

Each round in a block cipher should be invertible to make

Each round in a block cipher should be invertible to make the whole block invertible. Modern block ciphers use two approaches to achieve this. In the first approach, each component is invertible; in the second approach s ...

Suppose a pv module has the 1-sun i-v curve shown below

Suppose a PV module has the 1-sun I-V curve shown below. Within the module itself, the manufacturer has provided a pair of bypass diodes to help the panel deliver some power even when many of the cells are shaded. Each d ...

For a system specified by the transfer functionwrite sets

For a system specified by the transfer function write sets of state equations for DFII and its transpose, cascade, and parallel forms. Also write the corresponding output equations.

Charge is distributed uniformly with density within a

Charge is distributed uniformly with density within a spherical volume of radius a m and having its center at the origin. Using Gauss' law for the electric field, find the electric field intensity both inside and outside ...

Approximate by a number of terms of your choice through the

Approximate (by a number of terms of your choice) through the three forms of Fourier series expansion the periodic signal that in one period is given by Each time, a. Plot the approximate signal in time of three periods. ...

Consider two bar elements under a force at the tip using

Consider two bar elements under a force at the tip. Using the displacement controlled method, plot the load-displacement curve (F vs. u 2  and u 3 ). Increase the tip displacement u 3  up to 1.0 m by ten equal increments ...

For the following truth tablea give the dnf equation for

For the following truth table: a. Give the DNF equation for the table. b. Minimize the equation using a K-map. c. Show that the DNF is equivalent to the minimum representation using Boolean algebra.

1 why can the magnetic flux density vector be expressed as

1. Why can the magnetic flux density vector be expressed as the curl of another vector? 2. Discuss the analogy between the magnetic vector potential due to an infinitesimal current element and the electric scalar potenti ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen