Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Specify the triggering circuits which are used to trigger the  SCR? Describe the waveforms with neat circuit diagram.

2) describe what is power transistor? Specify its operation along with V-I characteristics and prepare down the benefits and drawbacks.

3) Describe the operation of the 1-phase semi converter with essential circuit diagram and waveforms. Estimate the benefits and drawbacks.

4) Describe the operation of the 3-phase full wave rectifier with RL – load and deduce the RMS and average output voltages.

5) Describe the operation of the step up DC chopper with the relevant circuit diagram and the waveform.

6) Describe the operation of 1-phase AC voltage controller with the R-L load with neat diagram and waveform.

7) Describe the operation of 3- phase voltage source inverter (1800 mode) with neat circuit diagrams and waveform.

8) Illustrate the operation of the single phase current source inverter with the neat circuit diagrams and the waveform.

9) describe the requirement of the UPS? Describe its operation with the help of block diagram and specify its drawbacks.

10) Describe the single phase converter fed DC motor drive with the help of circuit diagram and the waveforms.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913118

Have any Question? 


Related Questions in Electrical & Electronics

Lab 5 multisim1objectivestudents will be introduced to

LAB 5: Multisim 1. Objective Students will be introduced to National Instrument Multisim software for circuit design and analysis. You will conduct a DC operating point analysis simulation and you will use this to verify ...

1 what is the magnetic flux crossing an infinitesimal

1. What is the magnetic flux crossing an infinitesimal surface oriented parallel to the magnetic flux density vector? 2. For what orientation of the infinitesimal surface relative to the magnetic flux density vector is t ...

Assume an image uses a palette of size 8 out of the table

Assume an image uses a palette of size 8 out of the table used by JPEG (GIF uses the same strategy, but the size of the palette is 256), with the combination of the following colors with the indicated level of intensitie ...

Show that if a periodic signal xt is an even function of t

Show that if a periodic signal x(t) is an even function of t, then all the sine terms in its trigonometric Fourier series vanish, and if x(t) is an odd function of t, all the cosine terms vanish. In either case, show tha ...

An initially straight beam ab is bent into a circular arc

An initially straight beam AB is bent into a circular arc A'B' as shown in the figure. The deformation is specified as Where g(X 2 ) is a simple function of X 2 . (a) Find the deformation gradient in terms of g(X 2 ). (b ...

1 find two differential length vectors tangential to the

1. Find two differential length vectors tangential to the surface at the point (2, 4, 1) and then find a unit vector normal to the surface at that point. 2. A hemispherical bowl of radius 2 m lies with its base on the xy ...

A square block of surface area a on all sides is under pure

A square block of surface area A on all sides is under pure shear deformation due to the uniformly distributed load F on the top surface, as shown in the figure. The deformation of the block is such that the deformed coo ...

An estimate is needed on the lift provided by a hydrofoil

An estimate is needed on the lift provided by a hydrofoil wing section when it moves through water at 60 mph. Test data are available for this purpose from experiments in a pressurized wind tunnel with an airfoil section ...

1 in internet telephony explain how a call from alice can

1. In Internet telephony, explain how a call from Alice can be directed to Bob when he could be either in his office or at home? 2. Do you think H.323 is actually the same as SIP? What are the differences? Make a compari ...

1 why is a circle with its center at the center of the

1. Why is a circle with its center at the center of the Smith Chart known as a constant SWR circle? Where on the circle is the corresponding SWR value marked? 2. Using the Smith Chart, how do you find the normalized line ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro