Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe why we use XRA A instructions in detail?

2) What do you mean by Microcontroller and Microcomputer?

3) Describe Flags in detail with suitable ex.

4) How does the microprocessor distinguish between data and instruction?

5) Describe the architecture of microprocessors 8085.

6) Describe the pin diagram of 8085.

7) Describe the requirement of a program counter, stack pointer and status flags in the architecture of 8085 microprocessor.

8) Describe the memory mapped i/o addressing scheme in detail.

9) Design and describe the timing diagram of memory read cycle in detail.

10) Design and describe the timing diagram of memory prepare cycle with suitable ex.

11) Design and describe the timing diagram of opcode fetch cycle.

12) Describe the direct addressing modes and indirect addressing modes of 8085 with suitable ex.

13) Describe stack and describe stack related instructions in detail.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M910926

Have any Question? 


Related Questions in Electrical & Electronics

1 what are the two types of firewalls2 what is a vpn and

1. What are the two types of firewalls? 2. What is a VPN and why is it needed? 3. How do LANs on a fully private internet communicate? 4. Host A and host B use IPSec in the transport mode. Can we say that the two hosts n ...

1 in multimedia communication assume a sender can encode an

1. In multimedia communication, assume a sender can encode an image using only JPEG encoding, but the potential receiver can only decode an image if it is encoded in GIF. Can these two entities exchange multimedia data? ...

1 state faradays law in differential form for the general

1. State Faraday's law in differential form for the general case of an arbitrary electric field. How is it derived from its integral form? 2. What is meant by the net right-lateral differential of the x- and y-components ...

1 implement the d latch to include an enable line using

1. Implement the D latch to include an enable line using Logisim. The enable line will be used to control when the D latch is set, so it is only set if the clock and enable line are high. 2. Implement the D latch to incl ...

He potential distribution in a simplified model of a vacuum

he potential distribution in a simplified model of a vacuum diode consisting of cathode in the plane x = 0 and anode in the plane x = d and held at a potential V0 relative to the cathode is given by (a) Find the space ch ...

In example 612 we represented the function in fig 623 by

In Example 6.12, we represented the function in Fig. 6.23 by Legendre polynomials. a. Use the results in Example 6.12 to represent the signal g(t) in Fig. P6.5-8 by Legendre polynomials. b. Compute the error energy for t ...

The power output of a hydraulic turbine depends on the

The power output of a hydraulic turbine depends on the diameter D of the turbine, the density ρ of water, the height H of water surface above the turbine, the gravitational acceleration g, the angular velocity ω of the t ...

Question 1 design a suitable double -layer lap winding for

Question 1) Design a suitable double -layer lap winding for a 6-pole dc armature with 18 slots and two coil sides per slot. Give values of front-pitch, brack-pitch and commutator pitch. Draw the developed diagram and sho ...

For the following truth tablea give the dnf equation for

For the following truth table: a. Give the DNF equation for the table. b. Minimize the equation using a K-map. c. Show that the DNF is equivalent to the minimum representation using Boolean algebra.

1 state amperes force law as applied to current elements2

1. State Ampere's force law as applied to current elements. 2. Why is it not necessary for Newton's third law to hold for current elements? 3. What is the permeability of free space? What are its units? 4. Describe the m ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro