Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare down the different linear IC packages?

2) describe the function of voltage regulator.

3) prepare down the functions of a multimeter.

4) prepare down the two main categories of spectrum analysis?

5) What are the advantages of digital meter.

6) prepare down two advantages of potentimetric type digital voltmeter.

7) What are the types of C.R.O.?

8) Describe the purpose of using time base in a C.R.O.

9) prepare down any four fundamental components of a magnetic tape recorder.

10) What are the advantages of LED?

11) describe the frequency response of the 741 operational amplifier. Sketch the frequency response curve and describe its most important points.

12) Describe the principle of switch-mode power supplies with neat and suitable diagram?  prepare down its advantages and disadvantages.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M912660

Have any Question? 


Related Questions in Electrical & Electronics

An output interface in a switch is designed using the leaky

An output interface in a switch is designed using the leaky bucket algorithm to send 8000 bytes/s (tick). If the following frames are received in sequence, show the frames that are sent during each second. ? Frames 1, 2, ...

1 in an incompressible flow the volume of the fluid is

1. In an incompressible flow, the volume of the fluid is constant. Using the continuity equation, ∇·v = 0, show that the fluid volume change is zero. 2. Find Dv/Dt in polar coordinates by taking the derivative of the vel ...

A system has impulse response hn un - 3a determine the

A system has impulse response h[n] = u[n - 3]. a. Determine the impulse response of the inverse system h -1 [n]. b. Is the inverse stable? Is the inverse causal? c. Your boss asks you to implement h -1 [n] to the best of ...

1 find the minimum value of h for which the gate shown

1. Find the minimum value of h for which the gate shown will rotate counterclockwise if the gate cross section is (a) rectangular, 4 ft × 4 ft; (b) triangular, 4 ft at the base × 4 ft high. Neglect bearing friction. 2. A ...

Suppose that a continuous-time system is described by the

Suppose that a continuous-time system is described by the impulse response a. Compute the transfer function of the system. b. Find out if the system is BIBO stable. c. Plot the poles and the zeros of the system. d. Write ...

1 discuss briefly the application of gauss law for the

1. Discuss briefly the application of Gauss' law for the electric field to determine the electric field due to charge distributions. 2. State Gauss' law for the magnetic field. How is it derived from Faraday's law? 3. Wh ...

A force f is applied at the tip of the uniform bar element

A force F is applied at the tip of the uniform bar element shown in the figure. The initial length and the cross-sectional area of the bar are, respectively, A 0  and L 0 . The elastic modulus of the material is E. Calcu ...

1 define the parts of flow specification in intserv2

1. Define the parts of flow specification in IntServ. 2. Distinguish between guaranteed services and controlled-load services in IntServ. 3. IntServ is normally called a destination-based service. Explain the reason. 4. ...

The mass m of drops formed by liquid discharging by gravity

The mass M of drops formed by liquid discharging by gravity from a vertical tube is a function of the tube diameter D, liquid density, surface tension, and the acceleration of gravity. Determine the independent dimension ...

An exhaust stream leaving a semiconductor fabrication plant

An exhaust stream leaving a semiconductor fabrication plant contains 4 mol % volatile organic chemical, VOC, pollutant. Twenty-five cubic meters per minute enter the bottom of a packed absorption tower and flows counterc ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro