Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1: Describe the physical explanation of read diode and the avalanche multiplication procedure.

problem 2: Describe the principle of the negative resistances in IMPATT diode.

problem 3: Describe power output and efficiency of the IMPATT diode.

problem 4: How is TRATATT diode distinct from the IMPATT diode?

problem 5: What do you mean by PIN Diodes? Where are they after used? describe why?

problem 6: Describe the use of Pin diode as transmit or receive switch.

problem 7: What do you mean by BARITT diodes?

problem 8: What is the fundamental principle of operation of the BARITT diode?

problem 9: How is negative resistance effect of tunnel diode employed in oscillators?

problem 10: What do you understand by the term mode jumping in a magnetron?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M97483

Have any Question? 


Related Questions in Electrical & Electronics

State with reasons whether the following signals are

State with reasons whether the following signals are periodic or aperiodic. For periodic signals, find the period and state which of the harmonics are present in the series.

1 prove that a signal cannot be simultaneously timelimited

1. Prove that a signal cannot be simultaneously timelimited and bandlimited. 2. The signal x(t) = sin(0.7πt) cos(0.5πt) is sampled using Fs = 1 Hz to yield a discretetime signal x[n]. Next, x[n] is filtered using an idea ...

Consider a deformation of a rectangular bar whose deformed

Consider a deformation of a rectangular bar whose deformed geometry is given as x 1 = αX 1 , x 2 = βX 2 , x 3 = βX 3 When the material is an incompressible Mooney-Rivlin hyperelastic material with A 10  = 80 MPa and A 01 ...

1 explain how a 1 bit 4-to-1 mux can calculate any binary

1. Explain how a 1 bit 4-to-1 MUX can calculate any binary Boolean function. Because the MUX can calculate the result of any Boolean function, we call the MUX a univeral operation. 2. In Logism implement an 8 bit 4-to-1 ...

Does the velocity distribution in example satisfy

Does the velocity distribution in Example satisfy continuity? Example A rotating shaft, as illustrated in Figure, causes the fluid to move in circular streamlines with a velocity that is inversely proportional to the dis ...

In a real-time multimedia communication assume we have one

In a real-time multimedia communication, assume we have one sender and ten receivers. If the sender is sending multimedia data at 1 Mbps, how many RTCP packets can be sent by the sender and each receiver in a second? Ass ...

Using the frequency sampling method design a linear phase

Using the frequency sampling method, design a linear phase bandstop FIR filter with cutoff frequencies Ω c1 = π/3, Ω c2 = π/2, and L h = 13. Realize the design as a frequency sampling filter.

Determine the head loss between stations 1 and 2 in

Determine the head loss between stations (1) and (2) in Problem. Problem:- Oil (sp. gr. = 0.8) flows smoothly through the circular reducing section shown at 3 ft 3  /s. If the entering and leaving velocity profiles are u ...

A line assumed to be infinitely long and of unknown

A line assumed to be infinitely long and of unknown characteristic impedance when connected to a line of characteristic impedance 50 Ω produces a standing wave ratio of value 2 in the 50-Ω line. The same line when connec ...

1 for flow at very low speeds and with large viscosity the

1. For flow at very low speeds and with large viscosity (the so-called creeping flows) such as occur in lubrication, it is possible to delete the inertia terms, Dv/Dt, from the Navier- Stokes equation. For flows at high ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen