Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare down the different regions in characteristics of UJT.

2) describe the operation of zener diode and describe its characteristics in detail.

3) Describe the tunneling phenomenon in detail.

4) prepare detailed notes on varactor diode and PIN diode.

5) Describe the laser action for laser diode in detail.

6) describe the operation of LED and LCD in detail.

7) Describe the operation and characteristics of SCR.

8) Describe the operation and characteristics of TRIAC.

9) Describe the operation and characteristics of DIAC.

10) describe the turn OFF mechanism which is used for SCR?

11) What do you mean by forward break over voltage and reverse break over voltage?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M912009

Have any Question? 


Related Questions in Electrical & Electronics

In the system shown in figure 755 steady-state conditions

In the system shown in Figure 7.55, steady-state conditions are established with the switch S closed.At t = 0, he switch is opened. (a) Sketch the voltage and current along the system for t = 0-. (b) Find the total energ ...

Assignmentnbsp 1electric fields dielectrics generation and

Assignment  1 Electric Fields, Dielectrics, Generation and Measurements of HVDC & HVAC 1) For a coaxial cylindrical single-phase cable with an inner cable radius "r', outer grounded sheath radius "R' and an applied cable ...

A discuss asymptotic and bibo stabilities for the systems

a. Discuss asymptotic and BIBO stabilities for the systems described by the following transfer functions assuming that the systems are controllable and observable: b. Repeat part (a) for systems described by the followin ...

In problem find the rate of discharge if the frictional

In Problem , find the rate of discharge if the frictional head loss in the pipe is 3.2 v2 /g where v is the flow velocity in the pipe. Problem:- Referring to the figure, assume the flow to be frictionless in the siphon. ...

1 implement the half adder circuit on the breadboard2

1. Implement the half adder circuit on the breadboard. 2. Implement the full adder circuit on the breadboard. 3. Using the 2-bit adder presented in the chapter as a model, implement a 4-bit adder in Logisim. Implement an ...

1 how is the magnetic flux density defined in terms of

1. How is the magnetic flux density defined in terms of force on a current element? 2. How is the magnetic flux density defined in terms of force on a moving charge? 3. What are the units of the magnetic flux density? 4. ...

A the highest frequency in the spectrum x omega fig p81-8a

a. The highest frequency in the spectrum X (ω) (Fig. P8.1-8a) of a bandpass signal x (t) is 30 Hz. Hence, the minimum sampling frequency needed to sample x (t) is 60 Hz. Show the spectrum of the signal sampled at a rate ...

1 a 15 v aa battery that costs 1 is rated at 18 ah what is

1. A 1.5 V AA battery that costs $1 is rated at 1.8 Ah. What is its cost per kWh? 2. Suppose a 12-V battery bank rated at 200 Ah under standard conditions needs to deliver 600 Wh over a 12-h period each day. If they oper ...

A periodic signal xt is expressed by the following fourier

A periodic signal x(t) is expressed by the following Fourier series: a. Sketch the amplitude and phase spectra for the trigonometric series. b. By inspection of spectra in part (a), sketch the exponential Fourier series ...

1 what is a radiation pattern2 discuss the radiation

1. What is a radiation pattern? 2. Discuss the radiation pattern for the power density due to the Hertzian dipole. 3. Define the directivity of an antenna. What is the directivity of a Hertzian dipole?

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen