Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1)a) List and describe the important tools associated with the Integrated Development Environment (IDE) with respect to software development for embedded systems.

b) Describe the main characteristics of a real time embedded system which distinguishes it from non real time systems.

c) Describe the IEEE 802.11 protocol for wireless communication in embedded systems.

problem 2) With the help of a appropriate block diagram, describe the functions of main components of a real time embedded system.

b) Define and describe the following with respect to real time task and task scheduling.

i. Firm real time task.

ii. Task precedence and data sharing.

iii. Periodic task.

iv. Optimal scheduler.

v. Jitter.

problem 3)a) What do you understand by event driven schedulers? Compare them with clock driven schedulers. describe the different types of event driven schedulers.

b) describe the various tasks performed and task scheduling in an automatic washing machine.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M96282

Have any Question? 


Related Questions in Electrical & Electronics

A high-pass butterworth filter is to be designed with a

A high-pass Butterworth filter is to be designed with a cutoff frequency of f 3dB = 4 kHz. The gain magnitude is to be reduced by 12 dB at f = 3 kHz from the maximum gain value. Determine the required order of filter.

Using the results of given problem develop a program to

Using the results of given problem, develop a program to perform the analysis appearing in Example (b) for cast steel. A test routine will have to be developed to determine whether the results obtained are sufficiently c ...

There are four equal-value resistors in parallel with a 12

There are four equal-value resistors in parallel with a 12 V source, and 5.85 mA of current from the source. What is the value of each resistor?

Find the frequency and period of sine waves having an

Find the frequency and period of sine waves having an angular velocity of a. 754 rad/s. b. 8.4 rad/s. c. 6000 rad/s. d. 1/16 rad/s.

A galvanometer with a full scale current of 10 ma has a

A galvanometer with a full scale current of 10 mA has a resistance of 1000 Ω. The multiplying power (the ratio of measured current to galvanometer current) of 100 Ω shunt with this galvanometer is:

For a pn junction in which the it region is doped at tcn

For a pn junction in which the it region is doped at tcn times the concentration of the p region, in what region is the depletion region largest? By what factor?

Develop a verilog testbench model for the averager

Develop a Verilog testbench model for the averager described in Exercise 3.52. Exercise 3.52 Write a Verilog model of a circuit that calculates the average of four 16-bit 2s-complement signed numbers, without checking fo ...

The data below relate to failures of terminations in a

The data below relate to failures of terminations in a sample of 20 semiconductor devices. Each failure results from breaking of either the wire (W) or the bond (B), whichever is the weaker. The specification requirement ...

A three-stage 741 op-amp has a low-frequency open-loop gain

A three-stage 741 op-amp has a low-frequency open-loop gain of 200,000 and a dominant pole frequency of 10 Hz. The second and third poles are at the same frequency. If the phase margin is 70 degrees, determine the freque ...

For each metric prefix and unit shown write the

For each metric prefix and unit shown, write the abbreviation of the metric prefix with the unit symbol a. kiloWatt b. milliAmpere c. picoFarad d. nanosecond e. megOhm f. microHenry

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

A cola-dispensing machine is set to dispense 9 ounces of

A cola-dispensing machine is set to dispense 9 ounces of cola per cup, with a standard deviation of 1.0 ounce. The manuf

What is marketingbullwhat is marketing think back to your

What is Marketing? • "What is marketing"? Think back to your impressions before you started this class versus how you

Question -your client david smith runs a small it

QUESTION - Your client, David Smith runs a small IT consulting business specialising in computer software and techno

Inspection of a random sample of 22 aircraft showed that 15

Inspection of a random sample of 22 aircraft showed that 15 needed repairs to fix a wiring problem that might compromise

Effective hrmquestionhow can an effective hrm system help

Effective HRM Question How can an effective HRM system help facilitate the achievement of an organization's strate