Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe the functions of local and global variables in detail. Describe how sequence and case structures are implemented? describe it with suitable exs. describe about simple analog and digital VI’s using suitable exs in detail. prepare down the contribution of Intermediate VI’s? Give suitable exs.

2) Describe the GPIB architecture with its suitable timing diagram in detail. describe about RS232C / RS 485 interfacing technique in detail. Describe the concept of Image Processing with VI s. using simple ex. prepare a detailed note on the windowing and filtering.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913867

Have any Question? 


Related Questions in Electrical & Electronics

A hertzian dipole is situated parallel to a corner

A Hertzian dipole is situated parallel to a corner reflector, which is an arrangement of two plane, perfect conductors at right angles to each other, as shown by the crosssectional view in Figure 9.19. (a) Locate the ima ...

1 are both ah and esp needed for ip security why or why

1. Are both AH and ESP needed for IP security? Why or why not? 2. What are the two protocols discussed in this chapter that provide security at the transport layer? 3. What is IKE? What is its role in IPSec? 4. What is t ...

The performance of a journal bearing around a rotating

The performance of a journal bearing around a rotating shaft is a function of the following variables: Q, the rate of flow lubricating oil to the bearing in volume per unit time; D, the bearing diameter; N, the shaft spe ...

1 a synchronous alternator is supplying 09 pu power to the

(1) A synchronous alternator is supplying 0.9 p.u. power to the grid when a temporary three-phase short occurs on the interconnector. The power angle curves are:- Pre-fault = 2.0 sin(delta) During fault = 0.5 sin(delta) ...

1 when is it meaningful to attribute a group velocity to a

1. When is it meaningful to attribute a group velocity to a signal comprised of more than two frequencies? Why? 2. Discuss the propagation of a narrow-band amplitude modulated signal in a dispersive channel. 3. Discuss t ...

Tasks1learn how to use opendss2open and execute the epri

Tasks 1. Learn how to use OpenDSS 2. Open and execute the EPRI Test Circuit 24 model 3. Develop base case data sets of bus voltages and power flows 4. Provide analysis of the base case model: a. Feeder voltage profiles b ...

Instructions calculate the circuits by filling in all the

Instructions: Calculate the circuits by filling in all the blanks. 1. Et = 24 volts It = ______ amps Rt = ______ ohms 2. Et = 24 volts It = ______ amps Rt = ______ ohms 3. Et = 12 volts It = ______ amps Rt = ______ ohms ...

Question 1 design a suitable double -layer lap winding for

Question 1) Design a suitable double -layer lap winding for a 6-pole dc armature with 18 slots and two coil sides per slot. Give values of front-pitch, brack-pitch and commutator pitch. Draw the developed diagram and sho ...

1 if a communication is unicast how can we use rsvp which

1. If a communication is unicast, how can we use RSVP, which is designed for multicast in IntServ? 2. How can multicasting be achieved using DiffServ? 3. Why do we need Path and Resv messages in RSVP? 4. How many per-hop ...

Derive the 3 x 3 d matrix in equation for a two-dimensional

Derive the 3 X 3 [D] matrix in Equation for a two-dimensional MooneyRivlin material with three material parameters (A 10 , A 01 , and K). Use the perturbed Lagrangian method for near-incompressibility.

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen