Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) What do you understand by microcontroller?

2) Describe DJNZ instructions of intel 8051 microcontroller.

3) prepare down the function of RS1 and RS0 bits in flag register of intel 8051 microcontroller?

4) prepare a program using 8051 assembly language to change date 55H stored in the lower byte of the data pointer register to AAH by using rotate instruction.

5) prepare down the alternate functions for the port pins of port3.

6) State the single instruction, that clears the most significant bit of B

7) Describe the function of the pins PSEN and EA of 8051.

8) Describe the 16-bit registers DPTR and SP of 8051.

9) prepare down the name of special functions registers available in 8051.

10) Describe the register IE format of 8051.

11) describe Microprocessor and Microcontroller in detail and compare them.

12) prepare down the name of five interrupt sources of 8051.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M910977

Have any Question? 


Related Questions in Electrical & Electronics

1 does sip need to use the service of rtp explain2 we

1. Does SIP need to use the service of RTP? Explain. 2. We mentioned that SIP is an application-layer program used to provide a signaling mechanism between the caller and the callee. Which party in this communication is ...

An exhaust stream leaving a semiconductor fabrication plant

An exhaust stream leaving a semiconductor fabrication plant contains 4 mol % volatile organic chemical, VOC, pollutant. Twenty-five cubic meters per minute enter the bottom of a packed absorption tower and flows counterc ...

1 what is the basis behind the construction of the smith

1. What is the basis behind the construction of the Smith Chart? How does the Smith Chart simplify the solution of transmission-line problems? 2. Briefly discuss the mapping of the normalized line impedances from the com ...

Load flow calculation -in the power network shown below

Load Flow Calculation - In the power network shown below, node 1 is the slack bus, where the nodal voltage is defined as (1.0∠0 o ) pu, nodes 2, 4 and 5 are load buses, and node 3 is a generator bus where the voltage mag ...

A small cabin needs 24-kwh per day all of which is used in

A small cabin needs 2.4-kWh per day, all of which is used in the evening from 7 pm to 11 pm. If you decide to supply only enough 12-V battery storage to cover each evening, what should the minimum rated A-hr of batteries ...

1 what is a uniform plane wave2 why is the study of uniform

1. What is a uniform plane wave? 2. Why is the study of uniform plane waves important? 3. How is the surface current density vector defined? Distinguish it from the volume current density vector. 4. How do you find the c ...

Make an analytical model of a tornado using an irrotational

Make an analytical model of a tornado using an irrotational vortex (with velocity inversely proportional to distance from the center) outside a central core (with velocity directly proportional to distance). Assume that ...

A clean 15--efficient module stc 1 m2 in size has its own

A clean, 15-%-efficient module (STC), 1 m2 in size, has its own 90% effi- cient inverter. Its NOCT is 44° C and its rated power degrades by 0.5%/° C above the 25° C STC. a. What would its STC rated power be? b. Find the ...

1 discuss briefly the motional emf concept2 what is lenzs

1. Discuss briefly the motional emf concept. 2. What is Lenz's law? 3. How would you orient a loop antenna in order to obtain maximum signal from an incident electromagnetic wave which has its magnetic field linearly pol ...

1 repeat the previous problem without the assumption that

1. Repeat the previous problem without the assumption that the velocity in the heating section is negligible. The ratio of the flow area of the heating section to the chimney flow area is R. 2. Consider a 4-cm pipe that ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro