Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Describe the operation of the Magic tee and deduce the scattering matrix for it.

2) Specify and describe some of the properties of S parameters.

3) describe several types of the directional couplers with neat diagram.

4) Describe the construction and working of the four port circulator with reference to the Faraday rotation principle.

5) Describe the working of TWT amplifier with the help of neat sketch.

6) Sketch and describe the operation of the Klystron Oscillator.

7) Describe different modes of the operation of Gunn diode.

8) Describe the construction and operating principle of the IMPATT Diode.

9) Sketch the block diagram for slotted line method of VSWR measurement and describe.

10) Describe the measurement of load impedance through slotted line method. describe in detail.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M912972

Have any Question? 


Related Questions in Electrical & Electronics

The maximum pitching moment that is developed by the water

The maximum pitching moment that is developed by the water on a flying boat as it lands is noted as cmax The following are the variables involved in this action: a = angle made by flight path of plane with horizontal, β ...

1 how would you use amperes circuital law in differential

1. How would you use Ampere's circuital law in differential form to find the magnetic field adjacent to the current sheet? 2. If the current density on the infinite plane current sheet of Figure 4.2 were directed in the ...

1 what is the significance of a nonzero net right-lateral

1. What is the significance of a nonzero net right-lateral differential of and normal to the z-direction at a point in space? 2. If a pair of E and B at a point satisfies Faraday's law in differential form, does it neces ...

The spacing a between the plates of a parallel-plate

The spacing a between the plates of a parallel-plate waveguide is equal to 5 cm. The dielectric between the plates is free space. If a generator of fundamental frequency 1800 MHz and rich in harmonics excites the wavegui ...

A thin rod of diameter d is pulled at constant velocity

A thin rod of diameter d is pulled at constant velocity through a pipe of diameter D. If the wire is at the center of the pipe, find the drag per unit length of wire. The fluid filling the space between the rod and the i ...

What should be the spacing and the relative phase angle of

What should be the spacing and the relative phase angle of the current densities for an array of two infinite, plane, parallel current sheets of uniform densities, equal in magnitude, to confine their radiation to the re ...

When bill clinton took office in january 1993 he faced two

When Bill Clinton took office in January 1993, he faced two major economic problems: a large federal budget deficit and high unemployment resulting from a very slow recovery from the recession of 1990 to 1991. In his fir ...

Projecta cyclolron is an electrically - powered device that

Project A cyclolron is an electrically - powered device that is used to accelerate particles, specifically using both Electrostatic fields and Magneto static fields to accelerate charged particles outwards from a center ...

A rectangular plastic specimen of size 100 x 100 x 10

A rectangular plastic specimen of size 100 X 100 X 10 mm 3  is placed in a rectangular metal cavity. The dimensions of the cavity are 101 X 101 X 9 mm 3 . The plastic is compressed by a rigid punch until it is completely ...

Data at a rate of 1 million pulses per second are to be

Data at a rate of 1 million pulses per second are to be transmitted over a certain communications channel. The unit step response g(t) for this channel is shown in Fig. P2.7-1. a. Can this channel transmit data at the re ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen