Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Specify some of the benefits of the optical communication.

2) describe the skew rays.

3) describe the term group delay.

4) describe some of the causes for absorption?

5) What do you understand by the population inversion?

6) Describe the comparisons of the LED and LASER?

7) describe the several kinds of the optical connector.

8) describe the use of rise time budget?

9) describe the LED transmitter? Describe in detail.

10) describe the significance of the pre-amplifier?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M912982

Have any Question? 


Related Questions in Electrical & Electronics

1 for a point charge q situated at the point 1 2 0 find the

1. For a point charge Q situated at the point (1, 2, 0), find the potential difference between the point A(3, 4, 1) and the point B(5, 5, 0). 2. For the arrangement of a linear electric dipole consisting of point charges ...

The performance of a journal bearing around a rotating

The performance of a journal bearing around a rotating shaft is a function of the following variables: Q, the rate of flow lubricating oil to the bearing in volume per unit time; D, the bearing diameter; N, the shaft spe ...

The device in the schematic diagram below is a viscosity

The device in the schematic diagram below is a viscosity pump. It consists of a rotating drum inside of a stationary case. The case and the drum are concentric. Fluid enters at A, flows through the annulus between the ca ...

1 what is the significance of a nonzero net right-lateral

1. What is the significance of a nonzero net right-lateral differential of and normal to the z-direction at a point in space? 2. If a pair of E and B at a point satisfies Faraday's law in differential form, does it neces ...

1 discuss the reasoning associated with the intuitive

1. Discuss the reasoning associated with the intuitive extension of the fields due to the time-varying current and charges of the Hertzian dipole based on time-varying electromagnetic phenomena. 2. Explain the reason for ...

1 state and briefly discuss the basic definition of the

1. State and briefly discuss the basic definition of the curl of a vector. 2. What is a curl meter? How does it help visualize the behavior of the curl of a vector field? 3. Provide two examples of physical phenomena in ...

1 how would you use amperes circuital law in differential

1. How would you use Ampere's circuital law in differential form to find the magnetic field adjacent to the current sheet? 2. If the current density on the infinite plane current sheet of Figure 4.2 were directed in the ...

1 a 0635-cm hydraulic line suddenly ruptures 8 m from a

1. A 0.635-cm hydraulic line suddenly ruptures 8 m from a reservoir with a gage pressure of 207 kPa. Compare the laminar and inviscid flow rates from the ruptured line in cubic meters per second. 2. A common type of visc ...

An ltic system impulse response is given by ht ut-ut - 1a

An LTIC system impulse response is given by h(t) = u(t)-u(t - 1). a. Determine the transfer function H(s). Using H(s), determine and plot the magnitude response |H(jω)|. Which type of filter most accurately describes the ...

Consider a nonlinear elastic uniaxial bar element under tip

Consider a nonlinear elastic uniaxial bar element under tip force F = 100 N shown in Figure. The stress-strain relation is given in terms of Cauchy stress and engineering strain in the deformed geometry: σ11 = Eε 11 . Us ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen