Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare down the features of 8051 microcontroller.

2) prepare down the name of any four additional hardware features that are available in microcontrollers when compared to microprocessors.

3) prepare down the Hardware Resources available in 8051.

4) How to enable the interrupts, when 8051 is reset, all interrupts are disabled?

5) What do you mean by nested interrupts?

6) describe how will you double baud rate in 8051?

7) Describe software and hardware methods to start and stop timers in 8051.

8) prepare down the steps to program 8051 for serial data transfer.

9) prepare brief notes on interrupt priority.

10 prepare down the vector address and priority sequence of 8051 interrupts.

11)  prepare down a delay routine for 1 millisecond using timer 0 of 8051 for 12 MHz crystal frequency.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M910981

Have any Question? 


Related Questions in Electrical & Electronics

1 what is the difference between dm and dpcm2 what is the

1. What is the difference between DM and DPCM? 2. What is the problem with a speech signal that is compressed using the LPC method? 3. In transform coding, when a sender transmits the M matrix to a receiver, does the sen ...

1 the tank is accelerated upward at a uniform rate does the

1. The tank is accelerated upward at a uniform rate. Does the manometer level go up or down? 2. Glass viewing windows are to be installed in an aquarium. Each window is to be 0.6 m in diameter and to be centered 2 m belo ...

1 considering te modes in a dielectric slab guide specify

1. Considering TE modes in a dielectric slab guide, specify the fundamental mode and discuss the associated cutoff condition. 2. Compare the phenomenon at cutoff in a metallic waveguide with that at cutoff in an optical ...

1 two immiscible fluids of different density and viscosity

1. Two immiscible fluids of different density and viscosity are flowing between two parallel plates. Express the boundary conditions at the interface between the two fluids. 2. Determine the velocity profile for fluid fl ...

A signal is bandlimited to 12 khz the band between 9 and 12

A signal is bandlimited to 12 kHz. The band between 9 and 12 kHz has been corrupted by excessive noise to the point that the information within this band is nonrecoverable. Determine the minimum sampling rate for this si ...

1 in multimedia communication assume a sender can encode an

1. In multimedia communication, assume a sender can encode an image using only JPEG encoding, but the potential receiver can only decode an image if it is encoded in GIF. Can these two entities exchange multimedia data? ...

1 rework problem with the assumption that the momentum of

1. Rework Problem with the assumption that the momentum of the incoming air at section (1) is zero. Determine the exit velocity, v, and the magnitude of the pressure drop at section (1). 2. Air of density 1.21 kg/m 3  is ...

Power mosfet breakdown voltage 800v must conduct 10a when

power mosfet breakdown voltage 800v must conduct 10A when on with a maximum on state voltage 4v.If the current density in the mosfet must be limited to 200A/cm,estimate the conduxting area

1 discuss the duality between the radiation fields of a

1. Discuss the duality between the radiation fields of a small circular loop antenna with those of a Hertzian dipole at the center of the loop and aligned with its axis. 2. Compare the radiation resistance and directivit ...

1 what are the different kinds of magnetic materials2 what

1. What are the different kinds of magnetic materials? 2. What is the magnetization vector? How is it related to the magnetic flux density? 3. Discuss how magnetization current arises in a magnetic material. 4. State the ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro