Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) prepare down various stages involved in physical design cycle.

2) Compare different design styles based on performance and area

3) prepare down difference between Depth-First search and Breadth-First search methods.

4) With suitable ex, describe shortest path algorithms are used in physical design

5) Provide the classification of partitioning algorithms.

6) Describe Simulated Annealing algorithms for optimization of circuit partitioning.

7) Give the classification of Floor planning algorithm.

8) Describe Pin assignment problems in different design styles.

9) Describe problems associated during placement in physical design process.

10) Describe any one of the partition based placement algorithm.

11) Describe the various phases in global routing.

12) Describe problems associated during routing in gate array design process.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M910671

Have any Question? 


Related Questions in Electrical & Electronics

Two phases of a 144-kv three-phase distribution line serve

Two phases of a 14.4-kV three-phase distribution line serve a remote rural road (the neutral is also available). A farmer along the road has a 480 V feeder supplying 200 kW at 0.85 PF lagging of threephase loads, plus 60 ...

Some ac voltmeters provide dbm readings which are based on

Some AC voltmeters provide dBm readings which are based on a 600 Ω reference resistance in addition to the l mW reference power. If an AC voltmeter reads 16 on its dBm scale, what is the rms value of the voltage that cor ...

At a particular operating point of a reverse-biased pn

At a particular operating point of a reverse-biased pn junction, a change of I volt produces a transient current increase corresponding to a net charge flow of 0.1 pC. What is the corresponding depletion capa-citance of ...

Determine the inductive reactance in ohms of a 2-h coil

Determine the inductive reactance (in ohms) of a 2-H coil for a. dc and for the following frequencies: b. 25 Hz                                c. 60 Hz d. 2000 Hz e. 100,000 Hz

The op-amp in given figure has an open-loop differential

The op-amp in given Figure has an open-loop differential input resistance R i , an open-loop current gain Ai, and a zero output resistance. Break the feedback loop at an appropriate point, and derive the expression for t ...

Note how closely the b-h curve of cast steel in given

Note how closely the B-H curve of cast steel in given figure(a) matches the curve for the voltage across a capacitor as it charges from zero volts to its final value. a. Using the equation for the charging voltage as a g ...

Design a circuit with which you can reproduce the

Design a circuit with which you can reproduce the experiments in Illustration 45. You will obtain the burst signals, using the "Cut out" module, by cutting out a periodic sinusoidal signal in the time domain using this m ...

Write a checker always block for inclusion in the testbench

Write a checker always block for inclusion in the testbench using the revised memory bus functional model of Exercise 9.10. The checker should verify that derivative pixels written to memory by the Sobel accelerator have ...

The circuit parameters of the ideal shunt-shunt amplifier

The circuit parameters of the ideal shunt-shunt amplifier shown in given Figure are A z f  = 0.20 V/μA, β g  = 4.25/μA/V, and R i  = R o  = 500 . Determine the values and units of A z , R i f  , and R of  .

A channel of bandwidth 50 khz is available using

A channel of bandwidth 50 kHz is available. Using null-to-null RF bandwidths, what data rates may be supported by (a) BPSK, (b) coherent FSK (tone spacing = 1/2T), (c) DPSK, and (d) noncoherent FSK (tone = 2/T).spacing

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

A cola-dispensing machine is set to dispense 9 ounces of

A cola-dispensing machine is set to dispense 9 ounces of cola per cup, with a standard deviation of 1.0 ounce. The manuf

What is marketingbullwhat is marketing think back to your

What is Marketing? • "What is marketing"? Think back to your impressions before you started this class versus how you

Question -your client david smith runs a small it

QUESTION - Your client, David Smith runs a small IT consulting business specialising in computer software and techno

Inspection of a random sample of 22 aircraft showed that 15

Inspection of a random sample of 22 aircraft showed that 15 needed repairs to fix a wiring problem that might compromise

Effective hrmquestionhow can an effective hrm system help

Effective HRM Question How can an effective HRM system help facilitate the achievement of an organization's strate