Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1) A T.V signal bandwidth is 4.2 MHz is transmitted using binary Pulse Code Modulation. Provided that the number of quantization level is 512. Find out:

(a) Code word length

(b) Transmission band width

(c) Final bit rate

(d) Output signal to quantization noise ratio.

problem 2) Describe in detail about Minimum Shift keying. Compare it with QPSK.

problem 3) prepare a brief Note on:

a) Adaptive filters

b) Error probability in PCM

problem 4)a) Describe Delta Modulation in detail.

(b) What you mean by convolution codes? How they vary from Block codes?

problem 5)(a) Describe PAM/TDM system with suitable block diagram and describe briefly about the following:

a) Frame

b) Signaling rate

c) Transmission Bandwidth

d) synchronization

e) cross talk.

(b) Compare Sampling Techniques.

problem 6)(a) Provided an AWGN channel with 4 KHz bandwidth and the noise power spectral density n/2 =10–12 W/Hz. Signal power required at the receiver is 0.1mW. Compute the capacity of the channel.

(b) Why do we need to use Discrete PAM formats? Compare the various PAM formats on the basis of Power spectra and Bandwidth requirements.

problem 7) A sequence X has five symbols with probability P(x1)=0.4, P(x2)=0.19, P(x3)=0.16, P(x4)=0.15 and P(x5)=0.1.

(a) Construct a Shannon-Fano Code for X and find out efficiency of the code.

(b) Repeat for the Huffman code and compare the results.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M99552

Have any Question? 


Related Questions in Electrical & Electronics

1 what are the names of the protocols discussed in this

1. What are the names of the protocols, discussed in this chapter, that provide security for e-mail? 2. How does PGP create a set of security parameters? 3. What is the purpose of the Handshake Protocol in SSL? 4. What i ...

1 discuss how the cutoff condition arises in a waveguide2

1. Discuss how the cutoff condition arises in a waveguide. 2. Explain the relationship between the cutoff wavelength and the spacing between the plates of a parallel-plate waveguide based on the phenomenon at cutoff.

The mass m of drops formed by liquid discharging by gravity

The mass M of drops formed by liquid discharging by gravity from a vertical tube is a function of the tube diameter D, liquid density, surface tension, and the acceleration of gravity. Determine the independent dimension ...

1 which if either is a better anti-aliasing filter a

1. Which, if either, is a better anti-aliasing filter: a Chebyshev filter or an inverse Chebyshev filter? Fully justify your answer. 2. Consider the following specifications for bandpass signals. For each case, find the ...

The pressure rise across a pump p this term is proportional

The pressure rise across a pump P (this term is proportional to the head developed by the pump) may be considered to be affected by the fluid density ρ, the angular velocity ω, the impeller diameter D, the volumetric rat ...

Data at a rate of 1 million pulses per second are to be

Data at a rate of 1 million pulses per second are to be transmitted over a certain communications channel. The unit step response g(t) for this channel is shown in Fig. P2.7-1. a. Can this channel transmit data at the re ...

Show that if a periodic signal xt is an even function of t

Show that if a periodic signal x(t) is an even function of t, then all the sine terms in its trigonometric Fourier series vanish, and if x(t) is an odd function of t, all the cosine terms vanish. In either case, show tha ...

A compute and plot the impulse response of the systemb

a. Compute and plot the impulse response of the system. b. Compute and plot the step response of the system. c. Compute and plot the response of the system to the input signal

1 discuss how the superposition of two uniform plane waves

1. Discuss how the superposition of two uniform plane waves propagating at an angle to each other gives rise to a composite wave consisting of standing waves traveling bodily transverse to the standing waves. 2. What is ...

The operations and or and not are universal in that any

The operations AND, OR, and NOT are universal in that any Boolean function can be implemented using just these three gates. a. Prove by construction that the NAND gate is universal by creating AND, OR, and NOT gates usin ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro