Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1) Answer all the problems.

i) What is computer network?

ii) Differentiate between half duplex and full duplex?

iii) What is LAN? How it is different from WAN?

iv) What is network protocol?

v) What is TCP/IP model?

problem 2) Describe the need of computer network, with its applications.

problem 3) Describe various types of server use in computer field.

problem 4) Describe all the layers of OSI model with diagram.

problem 5) Answer all the problems.

i) What is Band Width and channel capacity?

ii) What is data encoding?

iii) What is the difference between FSK and PSK.

iv) What is the difference between Half Duplex and Full Duplex.

v) What is the difference between circuit switching and packet.

problem 6) Describe the various media use in computer network.

problem 7) Describe NRZ, RZ, Manchester and differential Manchester encoding.

problem 8) describe stop and wait, sliding window protocol with diagram.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M94334

Have any Question? 


Related Questions in Electrical & Electronics

Show that the time-average value of the magnitude of the

Show that the time-average value of the magnitude of the Poynting vector given by (4.68) is one-half its peak value. For an antenna radiating a time-average power of 150 kW, find the peak value of the electric field inte ...

1 the dam shown below is 100 m wide determine the magnitude

1. The dam shown below is 100 m wide. Determine the magnitude and location of the force on the inclined surface. 2. The float in a toilet tank is a sphere of radius R and is made of a material with ρ. An upward buoyant f ...

1 oil is supplied at the center of two long plates the

1. Oil is supplied at the center of two long plates. The volumetric flow rate per unit length is Q and the plates remain a constant distance, b, apart. Determine the vertical force per unit length as a function of the Q, ...

Assignmentpart 1 electricians tools1 which of the following

Assignment Part 1: Electricians' Tools 1. Which of the following types of symbols would be used on an electrical drawing for a large machine? A. Schematic symbols B. Blueprint symbols C. Pictorial symbols D. Wiring symbo ...

Question 1consider the following wireless receiver chain

Question 1: Consider the following wireless receiver chain consisting of a low noise amplifier (LNA), bandpass filter and mixer, as depicted below. The LNA receives its input signal from an antenna. a) If the input noise ...

Consider a deformation of a rectangular bar whose deformed

Consider a deformation of a rectangular bar whose deformed geometry is given as x 1 = αX 1 , x 2 = βX 2 , x 3 = βX 3 When the material is an incompressible Mooney-Rivlin hyperelastic material with A 10  = 80 MPa and A 01 ...

Show that if a periodic signal xt is an even function of t

Show that if a periodic signal x(t) is an even function of t, then all the sine terms in its trigonometric Fourier series vanish, and if x(t) is an odd function of t, all the cosine terms vanish. In either case, show tha ...

Using the data of problem determine the velocity head of

Using the data of Problem, determine the velocity head of the fluid leaving the impeller. What pressure rise would result from such a velocity head? Problem :- Sea water, ρ = 64 lbm/ft3 , flows through the impeller of a ...

A continuous-time signal x t deltat 12 is sampled at

A continuous-time signal x (t) = Δ((t = 1)/2) is sampled at three rates: 10, 2, and 1 Hz. Sketch the resulting sampled signals. Because x (t) is timelimited, its bandwidth is infinite. However, most of its energy is conc ...

1 a 16-scale model of a torpedo is tested in a water tunnel

1. A 1/6-scale model of a torpedo is tested in a water tunnel to determine drag characteristics. What model velocity corresponds to a torpedo velocity of 20 knots? If the model resistance is 10 lb, what is the prototype ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen