Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1)a) Sketch and describe the architecture of 8086 microprocessor with the help of a neat and well labelled diagram.

b) What do you mean by instruction queue? prepare down its advantages.

problem 2)a) Describe the register organization of 8086 with full description.

b) prepare down the function of flag registers. describe them in detail.

problem 3)a) Describe the different addressing modes of 8086 with the help of suitable exs.

b) prepare down the difference between a jump and a call instruction. What does the processor do in executing these instructions?

problem 4)a) Describe interrupt priorities, interrupt service routine and interrupt vector table.

b) Describe the function of following instructions: LOCK, TEST, XLAT, LES

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M99530

Have any Question? 


Related Questions in Electrical & Electronics

Write the answer of given problemsproblem 1 calculate the

Write the answer of given problems: Problem 1: Calculate the power dissipated when 5.5 V is applied across a resistor and 3 mA flows through it. Problem 2: A machine uses 50W for 12 hours. How many kilowatt-hours have be ...

Use matlab to solve problem 2-35problem 2-35using the

Use MATLAB to solve Problem 2-35. Problem 2-35: Using the Routh-Hurwitz criterion, determine the stability of the closed-loop system that has the following characteristic equations. Determine the number of roots of each ...

Question 1 for fig 1 the input voltage is dc and positive

Question 1. For Fig 1, the input voltage is dc and positive with the polarity shown. Specify how to implement the switches using a minimal number of diodes and transistors, such that the converter operates over the entir ...

The armature of a dc generator consists of 40 coils and

The armature of a d.c generator consists of 40 coils and each of coil has 20 turns. When the armature is rotated at 200 rads/s in a 4-pole field structure having a flux of 5m wb/pole and there are four paths in the armat ...

Problema 500 kv 150 mva three-phase transmission line will

Problem: A 500 kV, 150 MVA three-phase transmission line will use ACSR conductors. The line is 75 miles long, and the conductors are arranged in an equilateral triangle formation with sides of 9 ft. Nominal operating tem ...

Question 1the three bus-bar conductors in an outdoor

Question 1. The three bus-bar conductors in an outdoor substation are supported by units of post type insulators. Each unit consists of a stack of 3 pin type insulators fixed one on the top of the other. The voltage acro ...

Using the -y or y- conversion determine the current i for

Using the ?-Y or Y-? conversion, determine the current I for the networks of given figure. (E = 100 V  0° in each case.)

Consider the series-shunt feedback circuit in given figure

Consider the series-shunt feedback circuit in given Figure, with transistor parameters: h FE  = 120, V BE  (on) = 0.7 V, and V A  = ∞. (a) Determine the small-signal parameters for Q 1 , Q 2 , and Q 3 . Using nodal analy ...

The power crossing the air gap of a 60 hz four-pole

The power crossing the air gap of a 60 Hz, four-pole induction motor is 25 kW, and the power converted from electrical to mechanical form in the motor is 23.2 kW. (a) What is the slip of the motor at this time? (b) What ...

Write the answer of the given questionan overhead

Write the answer of the given question: An overhead transmission line conductor having a parabolic configuration weighs 1.925 kg/cm 2 per metre of the length .The area of X-section of the conductor is 2.2 cm 2 and the ul ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

A cola-dispensing machine is set to dispense 9 ounces of

A cola-dispensing machine is set to dispense 9 ounces of cola per cup, with a standard deviation of 1.0 ounce. The manuf

What is marketingbullwhat is marketing think back to your

What is Marketing? • "What is marketing"? Think back to your impressions before you started this class versus how you

Question -your client david smith runs a small it

QUESTION - Your client, David Smith runs a small IT consulting business specialising in computer software and techno

Inspection of a random sample of 22 aircraft showed that 15

Inspection of a random sample of 22 aircraft showed that 15 needed repairs to fix a wiring problem that might compromise

Effective hrmquestionhow can an effective hrm system help

Effective HRM Question How can an effective HRM system help facilitate the achievement of an organization's strate