Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1) What do you mean by transponder. describe it in detail?

problem 2) prepare down the advantages of satellite communication.

problem 3) describe the use of control bits in the data frame.

problem 4) describe the need of a predictor in detail?

problem 5) What do you understand by speech interpolation?

problem 6) What do you mean by co-operative synchronization in detail?

problem 7) prepare down the purpose of Guard time in TDMA.

problem 8) prepare down the limitations of CSSB.

problem 9) what do you mean by EIRP?

problem 10) What is the importance of link budget in a satellite link?

problem 11) Derive the basic transmission equation considering all the losses-prepare a note on SCPC systems and list its limitations if any. Discuss TDMA burst structure. A single carrier when modulated will occupy 9 MHz of an Intelsat V transponder can produce a (C/N)i of 14.7 dB at a standard earth station using the satellite's global beam. Assuming an 8000-pWp space segment noise allocation, how many telephone channels can the transponder carry.

problem 12) What is phase ambiguity in QPSK carrier recovery in Intelsat TDMA system? How this ambiguity is removed?

problem 13)(a) describe DA-FDMA system.

(b) Derive SNR for, optical satellite link receiver.

problem 14)(a) prepare a detailed note on pointing and tracking in optical satellite link.

(b) Describe the significance of UW detection in TDMA'

problem 15) prepare a detailed note on weather and military applications of satellite.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M98486

Have any Question? 


Related Questions in Electrical & Electronics

1 why is it that the distances r1 and r2 in the phase

1. Why is it that the distances r 1 and r 2 in the phase factors in equations (8.47a) and (8.47b) cannot be set equal to r, but the same quantities in the amplitude factors can be set equal to r? 2. What is an array fact ...

1 in an incompressible flow the volume of the fluid is

1. In an incompressible flow, the volume of the fluid is constant. Using the continuity equation, ∇·v = 0, show that the fluid volume change is zero. 2. Find Dv/Dt in polar coordinates by taking the derivative of the vel ...

1 consider three equally spaced sources of strength m

1. Consider three equally spaced sources of strength m placed at (x, y) = ( a, 0),(0, 0), and (a, 0). Sketch the resulting streamline pattern. Are there any stagnation points? 2. Sketch the streamlines and potential line ...

Assignment questiondesign automatic fan speed controller

Assignment Question Design automatic fan speed controller based on the temperature variation in room using a microcontroller. Abstract: The electronic Circuit used to control the speed of fan based on temperature variati ...

If the hertzian dipole in figure 919 is situated at a

If the Hertzian dipole in Figure 9.19 is situated at a distance from the corner and equidistant from the two planes, find the ratio of the radiation field at a point broadside to the dipole and away from the corner to th ...

1 explain the term internal inductance2 what is meant by

1. Explain the term internal inductance. 2. What is meant by the quasistatic extension of the static field in a physical structure? 3. Outline the steps involved in the electroquasistatic field analysis of a parallel pla ...

Problem 1 an amplifier is observed to have an output noise

Problem 1: An amplifier is observed to have an output noise rms-voltage of 1.0 μV. If the noise bandwidth is 25 kHz, determine the noise spectral density of the amplifier. Problem 2: A piezeoresistive sensor has a therma ...

An auto lift consists of 3602-cm-diameter ram that slides

An auto lift consists of 36.02-cm-diameter ram that slides in a 36.04-cm-diameter cylinder. The annular region is filled with oil having a kinematic viscosity of 0.00037 m 2  /s and a specific gravity of 0.85. If the rat ...

Figure 3012 shows a router using fifo queuing at the input

Figure 30.12 shows a router using FIFO queuing at the input port. The arrival and required service times for seven packets are shown below; ti means that the packet has arrived or departed i ms after a reference time. Th ...

Using the frequency sampling method design a linear phase

Using the frequency sampling method, design a linear phase bandstop FIR filter with cutoff frequencies Ω c1 = π/3, Ω c2 = π/2, and L h = 13. Realize the design as a frequency sampling filter.

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro