Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1)a) Construct a feedback shift register of length m=5 and feedback connections [6,5,2,1] and initial state is 100000.Obtain the feedback and output code of the Maximal Length sequence. Verify whether it satisfies balance property

b) Derive properties of Cyclic codes.

problem 2) Perform Viterbi Algorithm to the received sequence [1111111101] for a ½ convolution encoder with constraint length 3 and whose paths are [1,1,1] and [1,0,1]. Decode the errors and give the corresponding message. Draw the Convolution encoder, Trellis code and State Diagram (Initial states are a=00, b=10, c=01 and d=11).

problem 3)a) Derive probability of error for Binary Phase shift Keying modulation and relate it with Q function. Plot the constellation diagram. Describe the transmitter and Receiver section of BPSK.

b) Compute the transmitted power spectral density of a coherent frequency hop system. The system employs BPSK modulation with a data rate of 1 MBPS. The hop rate is 100 * 103 hops/sec. The frequency spacing equals the data rate and four frequencies are employed.

problem 4)a) Describe the performance of coherent Direct sequence spread spectrum in pulse noise jamming.

b) Plot a constellation diagram for QPSK modulation and estimate the minimum Euclidean distance.

problem 5) Describe in detailed about Broad band ISDN Architecture.

b) Describe the effects on different cases of congestion in Frame relays.

problem 6)a) Describe the operation of DLCI in a Frame Relay Network.

b) Describe in detailed about SONET system hierarchy.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M96330

Have any Question? 


Related Questions in Electrical & Electronics

Does a large bolt-to-joint stiffness ratio increase or

Does a large bolt-to-joint stiffness ratio increase or decrease the possibility of fatigue failure of the bolt and why? Name at least three bolt, thread, or bolt and thread configurations which can improve the fatigue re ...

1 what is meant by the dominant mode why are waveguides

1. What is meant by the dominant mode? Why are waveguides designed so that they propagate only the dominant mode? 2. Why is the dimension b of a rectangular waveguide generally chosen to be less than or equal to one-half ...

1 what is the total distance around the circumference of a

1. What is the total distance around the circumference of a circle of radius 1 m? What is the total vector distance around the circle? 2. What is the total surface area of a cube of sides 1 m? Assuming the normals to the ...

Consider a uniform bar with a cross-sectional area a 2

Consider a uniform bar with a cross-sectional area, A = 2 10 -4  m 2 , and a unit length, L = 1 m. The bar shows elastoplastic material behavior, as depicted in the figure. The plastic deformation starts at yield stress ...

A cryptographic hash function needs to be second preimage

A cryptographic hash function needs to be second preimage resistant, which means that given the message M and the message digest d, we should not be able to find any other message, M′, whose digest is d. In other words, ...

Consider the problem of identifying the nonlinear

Consider the problem of identifying the nonlinear discrete-time system in (9.9.4) using a raised-cosine RBF network. Let the number of past inputs be m = 1 and the number of past outputs be n = 1. Suppose the range of va ...

1 show that the radiation fields given by equations 925a

1. Show that the radiation fields given by equations (9.25a) and (9.25b) do not by themselves satisfy both of Maxwell's curl equations. 2. Find the value of r at which the amplitude of the radiation field term in equatio ...

The power output of a hydraulic turbine depends on the

The power output of a hydraulic turbine depends on the diameter D of the turbine, the density ρ of water, the height H of water surface above the turbine, the gravitational acceleration g, the angular velocity ω of the t ...

1 why is it that the distances r1 and r2 in the phase

1. Why is it that the distances r 1 and r 2 in the phase factors in equations (8.47a) and (8.47b) cannot be set equal to r, but the same quantities in the amplitude factors can be set equal to r? 2. What is an array fact ...

Determine the spacing relative amplitudes and phase angles

Determine the spacing, relative amplitudes, and phase angles of current densities for an array of two infinite plane parallel current sheets required to obtain a radiation characteristic such that the field radiated to o ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro