Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Deduce an expression for magnetic field intensity and magnetic flux density because of finite and infinite line.

2) Deduce an expression for magnetic field intensity and magnetic flux density because of circular coil.

3)a) Deduce the expression for force between two current carrying conductors.

b) Iron ring with cross sectional area of 3cm square and mean circumference of 15 cm is wound with 250 turns wire carrying current of 0.3A. Relative permeability of ring is 1500. Compute the flux established in the ring.

4) Deduce an expression for torque developed in rectangular closed circuit carrying current I in a uniform field.

5) Define Ampere’s circuital law and describe applications of Ampere’s Circuital law in detail.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911063

Have any Question? 


Related Questions in Electrical & Electronics

1 how would you use amperes circuital law in differential

1. How would you use Ampere's circuital law in differential form to find the magnetic field adjacent to the current sheet? 2. If the current density on the infinite plane current sheet of Figure 4.2 were directed in the ...

An estimate is needed on the lift provided by a hydrofoil

An estimate is needed on the lift provided by a hydrofoil wing section when it moves through water at 60 mph. Test data are available for this purpose from experiments in a pressurized wind tunnel with an airfoil section ...

1 if the plate shown is inclined at an angle as shown what

1. If the plate shown is inclined at an angle as shown, what are the forces F x  and F y  necessary to maintain its position? The flow is frictionless. 2. A steady, incompressible, frictionless, two-dimensional jet of fl ...

A the highest frequency in the spectrum x omega fig p81-8a

a. The highest frequency in the spectrum X (ω) (Fig. P8.1-8a) of a bandpass signal x (t) is 30 Hz. Hence, the minimum sampling frequency needed to sample x (t) is 60 Hz. Show the spectrum of the signal sampled at a rate ...

Objectivesthe objectives of this experiment are1 to

OBJECTIVES: The objectives of this experiment are: 1) To investigate the operation of automatic reset circuits. 2) To understand the difference between a positive edge triggered, negative edge triggered, and a level trig ...

1 find the unit vector normal to the plane then find the

1. Find the unit vector normal to the plane . Then find the distance from the origin to the plane. 2. Write the expression for the differential length vector dl at the point (1, 2, 8) on the straight line and having the ...

1 state the divergence theorem and discuss its application2

1. State the divergence theorem and discuss its application. 2. What is the divergence of the curl of a vector? 3. Summarize Maxwell's equations in differential form. 4. Are all Maxwell's equations in differential form i ...

Solve problem using the secant method do not use the

Solve Problem using the secant method. Do not use the incremental force method. Discuss about the convergence rate. Problem :- Consider a uniform bar with a constant Young's modulus, E = 100 MPa; cross-sectional area, A ...

Consider the complementary-bjt class b output stage and

Consider the complementary-BJT class B output stage and neglect the effects of finite VBE and VCEsat. For ±10-V power supplies and an 8 ohm load resistance, what is the maximum sine-wave output power available? What supp ...

For an ltid system specified by the equationa find the

For an LTID system specified by the equation a. Find the amplitude and the phase response. b. Find the system response y[n] for the input x[n] = cos (0.5k - (π/3)).

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen