Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1)(a) Create the AM by using Switching Modulator.

(b) Describe the different systems based on Bandwidth and transmitted power.

2)(a) Create the SSB wave by using phase discrimination method.

(b) Describe in detail about on frequency translation.

3) describe the Indirect method and Direct method of generating the FM wave.

4) Describe the method of creating the FM signal by using Armstrong modulator.

5) Find the practical synchronous receiving system to demodulate the DSB – SC waves by using Costas Loop.

6)(a) Describe about the radio detector in detail.

(b) prepare down the characteristics of Receivers.

7)(a) Describe about the TDM in detail.

(b) What do you mean by Quadrature Multiplexing?

8)(a) Describe the method of creating Pulse Amplitude Modulation signal in detail.

(b) describe in detail about cross talk.

9) Describe the noise model for FM receivers in detail and find figure of merit for the same.

10) Describe the Noise Model for the following:

(a) describe for coherent detection.

(b) AM system using envelope detection.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913631

Have any Question? 


Related Questions in Electrical & Electronics

Compute and plot the solution of the difference equation yn

Compute and plot the solution of the difference equation y[n] þ y[n 1] = 2x[n] þ x[n 1], where x[n] = 0.8n u[n] assuming zero initial conditions. Moreover, verify your answer (a) by examining if the derived solution sati ...

1 what is the voltage reflection coefficient at the

1. What is the voltage reflection coefficient at the junction between two transmission lines? How are the current reflection coefficient and the voltage and current transmission coefficients related to the voltage reflec ...

Determine if the filters with the following transfer

Determine if the filters with the following transfer functions are physically realizable. If they are not realizable, explain if and how they can be approximately realized. Be as specific as possible. (c) H(ω)=2πδ(ω)

Find the disruptive and visual corona voltage of a grid

find the disruptive and visual corona voltage of a grid line operating at 132kv ,conductor diameter =1.9cm,conductor spacing =3.81m,temp=44,pressure=73.7,conductor surface factor ;fine weather=0.8;rough weather=0.66

1 state gauss law for the electric field in differential

1. State Gauss' law for the electric field in differential form. How is it derived from its integral form? 2. What is meant by the net longitudinal differential of the components of a vector field? 3. Give an example in ...

Tasks1learn how to use opendss2open and execute the epri

Tasks 1. Learn how to use OpenDSS 2. Open and execute the EPRI Test Circuit 24 model 3. Develop base case data sets of bus voltages and power flows 4. Provide analysis of the base case model: a. Feeder voltage profiles b ...

Question 1 match the statements below with the answer that

Question 1: Match the statements below with the answer that best matches. Your choices are: Efficiency Full Load Summation of Losses Differential Power Losses Speed Regulation No-Load Power Regulation The same as the num ...

In the system shown in figure 755 steady-state conditions

In the system shown in Figure 7.55, steady-state conditions are established with the switch S closed.At t = 0, he switch is opened. (a) Sketch the voltage and current along the system for t = 0-. (b) Find the total energ ...

The relationship between deformed and undeformed

The relationship between deformed and undeformed coordinates for the pure bending of a plane-strain solid is given as Compare the engineering strain and Lagrangian strain. Show that the two strain measures become identic ...

1 find the minimum value of h for which the gate shown

1. Find the minimum value of h for which the gate shown will rotate counterclockwise if the gate cross section is (a) rectangular, 4 ft × 4 ft; (b) triangular, 4 ft at the base × 4 ft high. Neglect bearing friction. 2. A ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen