Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) What do you mean by an internet? Suppose there is an organization where internet is require and describe it in detail with neat and suitable diagram.

2) Describe about datagram approach and compare with circuit switching in detail.

3)a) Describe Routing Table and Routing Module in detail.

b) A company is arranged site address 201.70.64.0. Company requires 6 subnets. Draw the subnets.

4)a) How is looping problem solved by switches and by routers? How do switches/routers handle link failure?

b) Describe the IP addressing.

5)a) Convert the following IP address from dotted decimal notation to binary notation:

i. 114.34.2.8

ii. 129.14.6.8

b. Convert the following IP address from binary notation to dotted decimal notation:

i. 01111111 11110000 01100111 01111101

ii. 11110111 11110011 10000111 11011101

c. Determine the net and host id of the IP addresses:

i. 241.34.2.8

ii. 11101111 11110111 11000111 00011101d. In a class C subnet, determine the network address

i. IP address: 182.44.82.1

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911234

Have any Question? 


Related Questions in Electrical & Electronics

Figure 3013 shows a router using priority queuing at the

Figure 30.13 shows a router using priority queuing at the input port. The arrival and required service times (transmission time is negligible) for 10 packets are shown below; ti means that the packet has arrived i ms aft ...

The spacing a between the plates of a parallel-plate

The spacing a between the plates of a parallel-plate waveguide is equal to 5 cm. The dielectric between the plates is free space. If a generator of fundamental frequency 1800 MHz and rich in harmonics excites the wavegui ...

A line assumed to be infinitely long and of unknown

A line assumed to be infinitely long and of unknown characteristic impedance is connected to a line of characteristic impedance on which standing wave measurements are made. It is found that the standing wave ratio is 3 ...

1 discuss the input behavior of a short-circuited line for

1. Discuss the input behavior of a short-circuited line for frequencies slightly beyond those for which the quasistatic approximation is valid. 2. What are the boundary conditions for the voltage and current at the junct ...

1 write a function that accepts a number t0 as input

1. Write a function that accepts a number t0 as input argument and returns the unit step function u(t t0). Your function should also create the graph of u(t t0) in a proper time interval. 2. Write a function that accepts ...

An ltic system impulse response is given by ht ut-ut - 1a

An LTIC system impulse response is given by h(t) = u(t)-u(t - 1). a. Determine the transfer function H(s). Using H(s), determine and plot the magnitude response |H(jω)|. Which type of filter most accurately describes the ...

1 assume fixed-sized packets arrive at a router with a rate

1. Assume fixed-sized packets arrive at a router with a rate of three packets per second. Show how the router can use the leaky bucket algorithm to send out only two packets per second. What is the problem with this appr ...

1 explain the self-consistency condition for waveguiding in

1. Explain the self-consistency condition for waveguiding in a dielectric slab waveguide. 2. Discuss the dependence of the number of propagating modes in a dielectric slab waveguide on the ratio of the thickness d of the ...

1 a 16-scale model of a torpedo is tested in a water tunnel

1. A 1/6-scale model of a torpedo is tested in a water tunnel to determine drag characteristics. What model velocity corresponds to a torpedo velocity of 20 knots? If the model resistance is 10 lb, what is the prototype ...

An output interface in a switch is designed using the leaky

An output interface in a switch is designed using the leaky bucket algorithm to send 8000 bytes/s (tick). If the following frames are received in sequence, show the frames that are sent during each second. ? Frames 1, 2, ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen