Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) describe the term:

a) Modulation

b) Amplitude modulation

c) Frequency modulation

d) Wavelength

2) Describe the following the given term:

a) Modulation index for AM

b) Modulation index for FM

c) Frequency deviation

d) Bandwidth.

3) Construct the waveforms for the amplitude modulation.

4) Design the waveforms for phase and for the frequency modulation.

5) describe the analog modulation and digital modulation.

6) Draw and describe the basic block diagram of communication system.

7) describe the requirement of the modulation.

8) prepare down the differences between the simplex and duplex with the help of sketch.

9) describe the term electromagnetic spectrum with the help of suitable diagram.

10) List out some of the advantages of AM

11) describe the disadvantages and also some of the applications of AM.

12) Specify some of the advantages and disadvantages and also list applications of the FM. 

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M911858

Have any Question? 


Related Questions in Electrical & Electronics

A discuss asymptotic and bibo stabilities for the systems

a. Discuss asymptotic and BIBO stabilities for the systems described by the following transfer functions assuming that the systems are controllable and observable: b. Repeat part (a) for systems described by the followin ...

A cryptographic hash function needs to be second preimage

A cryptographic hash function needs to be second preimage resistant, which means that given the message M and the message digest d, we should not be able to find any other message, M′, whose digest is d. In other words, ...

Consider a microphone intended for use in a music recording

Consider a microphone intended for use in a music recording studio. Determine a suitable frequency response (lowpass, highpass, bandpass, or bandstop) for the microphone, and provide suitable values (such as δp and ωs) t ...

1 briefly outline the reasoning used for the removal of the

1. Briefly outline the reasoning used for the removal of the inconsistency with Maxwell's equations of the intuitively derived fields due to the Hertzian dipole. 2. Discuss the characteristics of the complete electromagn ...

Question 1a for the circuit shown in figure 1 sketch the

Question 1. (a) For the circuit shown in FIGURE 1 sketch the voltage waveform across the secondary winding of the transformer. On the same diagram sketch the load voltage waveform. The sketches should take into account d ...

For the structure of figure 610 continue the analysis

For the structure of Figure 6.10, continue the analysis beyond the quasistatic extension to obtain the input impedance correct to the third power in . Determine the equivalent circuit.

The tank in the previous problem feeds two lines a 4-cm

The tank in the previous problem feeds two lines, a 4-cm pipe that exits 10 m below the water level in the tank and a second line, also 4 cm in diameter runs from the tank to a station 20 m below the water level in the t ...

In a real-time multimedia communication assume we have one

In a real-time multimedia communication, assume we have one sender and ten receivers. If the sender is sending multimedia data at 1 Mbps, how many RTCP packets can be sent by the sender and each receiver in a second? Ass ...

1 why is it necessary to have the minus sign associated

1. Why is it necessary to have the minus sign associated with the time rate of increase of magnetic flux on the right side of Faraday's law? 2. What is electromotive force? 3. What are the different ways in which an emf ...

1 what is a boundary condition how do boundary conditions

1. What is a boundary condition? How do boundary conditions arise and how are they derived? 2. Summarize the boundary conditions for the general case of a boundary between two arbitrary media, indicating correspondingly ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro