Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

Answer the following problems.

problem 1) describe typical TDMA frame format.

problem 2) Earth station uses a 3m diameter parabolic antenna to receive a 4-GHz signal from a geostationary satellite. If the satellite transmitter delivers 10W into a 3-m diameter transmitting antenna and the satellite is located 36,000 km from the receiver, what is power received?

problem 3) describe a simplified block diagram of a communications satellite transponder.

problem 4) describe with full specifications the transmission of broadcast-quality TV signals from a ground station.

problem 5) Compare and describe significant features of different digital modulation techniques.

problem 6) describe and compare SCPC and CSSB systems.

problem 7) prepare brief notes on the following:

(a) Erlang call congestion formula.

(b) Satellite link analysis.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M98502

Have any Question? 


Related Questions in Electrical & Electronics

Below is the governing differential equation of

Below is the governing differential equation of one-dimensional bar under uniformly distributed load. Using one bar element, calculate the displacement at x = L and x = 1/2L. Compare these displacements with that of the ...

Problem 1 - a consider an isolated generating station with

Problem 1 - a. Consider an isolated generating station with a local load and with: Governor time constant and gain T G = 0, K G = 1, Turbine time constant and gain T T = 1, K T = 1 System time constant T P = 20 Total dam ...

Power mosfet breakdown voltage 800v must conduct 10a when

power mosfet breakdown voltage 800v must conduct 10A when on with a maximum on state voltage 4v.If the current density in the mosfet must be limited to 200A/cm,estimate the conduxting area

Determine the nyquist sampling rate and the nyquist

Determine the Nyquist sampling rate and the Nyquist sampling interval for the signals a. sinc 2 (100πt) b. 0.01 sinc 2 (100πt) c. sinc(100πt) + 3 sinc 2 (60πt) d. sinc(50πt) sinc (100πt)

Find the zero-state response yt of the network in fig p44-1

Find the zero-state response y(t) of the network in Fig. P4.4 -1 if the input voltage x(t) = te-tu(t). Find the transfer function relating the output y(t) to the input x(t). From the transfer function, write the differen ...

Consider the complementary-bjt class b output stage and

Consider the complementary-BJT class B output stage and neglect the effects of finite VBE and VCEsat. For ±10-V power supplies and an 8 ohm load resistance, what is the maximum sine-wave output power available? What supp ...

1 summarize maxwells equations in integral form discuss the

1. Summarize Maxwell's equations in integral form. Discuss the interdependence of timevarying electric and magnetic fields, with the aid of an example. 2. Which two of the Maxwell's equations are independent?

Boiler efficiency and heat losses heat balence sheet boiler

Boiler efficiency and heat losses, heat Balence sheet, boiler draught, high pressure boiler

The spacing a between the plates of a parallel-plate

The spacing a between the plates of a parallel-plate waveguide is equal to 5 cm. The dielectric between the plates is free space. If a generator of fundamental frequency 1800 MHz and rich in harmonics excites the wavegui ...

1 why is it necessary to have the displacement current term

1. Why is it necessary to have the displacement current term on the right side of Ampere's circuital law? 2.28. When can you say that the current in a wire enclosed by a closed path is uniquely defined? Give two examples ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen