Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

1) Define what is meant by the thermal contact resistance.

2) Describe the one dimensional steady heat conduction equation through the composite wall.

3) describe the several kinds of fins.

4) Describe the Biot number and describe its importance.

5) Clearly describe the difference between the natural convection heat transfer and the forced convection heat transfer.

6) describe the prandtl Number and describe its importance.

7) Discuss what is fouling? describe its effect over the heat exchanger.

8) Discuss the effectiveness of heat exchanger.

9) describe what is meant by diffusion coefficient? Provide its unit

10) describe what is meant by Schmidt number.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M913601

Have any Question? 


Related Questions in Electrical & Electronics

A large amount of energy e is suddenly released in the air

A large amount of energy E is suddenly released in the air as in a point of explosion. Experimental evidence suggests the radiusr of the high-pressure blast wave depends on time t as well as the energy E and ρ the densit ...

1 what is the voltage reflection coefficient at the short

1. What is the voltage reflection coefficient at the short circuit for a short-circuited line? 2. Can the transmitted wave current at the junction between two transmission lines be greater than the incident wave current? ...

1 how would you use amperes circuital law in differential

1. How would you use Ampere's circuital law in differential form to find the magnetic field adjacent to the current sheet? 2. If the current density on the infinite plane current sheet of Figure 4.2 were directed in the ...

Repeat problem with the elastic constants of the plastic

Repeat Problem with the elastic constants of the plastic defined as E = 10 GPa and ν = 0.485. Problem:- A rectangular plastic specimen of size 100 X 100 X 10 mm 3  is placed in a rectangular metal cavity. The dimensions ...

1 state amperes circuital law2 what are the units of the

1. State Ampere's circuital law. 2. What are the units of the magnetic field intensity vector? 3. What are the units of the displacement flux density vector? 4. What is displacement current? Give an example involving dis ...

1 in kademlia assume m 4 and active nodes are n4 n7 and

1. In Kademlia, assume m = 4 and active nodes are N4, N7, and N12. Where is the key k3 stored in this system? 2. In Chord, assume the size of the identifier space is 16. The active nodes are N3, N6, N8, and N12. Show the ...

1 discuss the solutions for the transmission-line equations

1. Discuss the solutions for the transmission-line equations in frequency domain. 2. Discuss the propagation constant and characteristic impedance associated with wave propagation on transmission lines. 3. What is the bo ...

1 discuss the reciprocity associated with the transmitting

1. Discuss the reciprocity associated with the transmitting and receiving properties of an antenna. Can you think of a situation in which reciprocity does not hold? 2. What is the receiving pattern of a loop antenna? 3. ...

1 state faradays law in differential form for the general

1. State Faraday's law in differential form for the general case of an arbitrary electric field. How is it derived from its integral form? 2. What is meant by the net right-lateral differential of the x- and y-components ...

Can sell them for on a dollarper-square meter basis to make

can sell them for on a dollarper-square meter basis to make the resulting PV system no more expensive than when using a fixed mount system. Using simple dc, STC ratings along with the following assumptions, how much can ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro