Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1:

a) To realize a non isolated bidirectional uind DC-DC converter battery charger with simulation; (Vin= 400V, Vo= 360V, Po= 3kW); Don’t use Buck/Boost topology.

b) Topologies other than Buck/Boost are needed. No isolation is needed;

c) Build the Matlab/Simulink/Simpowersystems Model and simulate the voltage/current stress; (Simulink Models and simulation data to be delivered)

problem 2
:

Build the model in MATLAB/Simulink and simulate the feasibility of the Battery SOC estimation algorithm using Kalman filtering method.

Build the Matlab/Simulink/Simpowersystems Model and simulate the SOC estimation; (Simulink Models and simulation data to be delivered).


problem 3
: Simulate a (400VDC, 50kW) battery-driven motor drive system to drive any one of the motors shown below:

  • Induction Motor,
  • PMSM,
  • BLDC

(Simulink Models and simulation data to be delivered).

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M9530

Have any Question? 


Related Questions in Electrical & Electronics

How much potential energy is contained in the arrangement

How much potential energy is contained in the arrangement of 1 µC charges at spherical coordinates (1m,π/2, 0), (1m,π/2,π/2), (1m,π/2, π) , and (1m,π/2,3π/2 )?

Suppose you want to learn the characteristics of a certain

Suppose you want to learn the characteristics of a certain filter. A white noise source with an amplitude of 15 watts/Hz is connected to the input of the filter. The power spectrum of the filter output is measured and fo ...

A 100hp 60hz three-phase induction motor has a slip of 003

A 100hp, 60Hz, three-phase induction motor has a slip of 0.03 at full load. Compute the efficiency of the motor at full load when the friction and windage losses are 900W, the stator core loss is 4200W, and the stator co ...

A a flux of 02 x 10-4nbspwb will establish sufficient

a. A flux of 0.2 x 10 -4  Wb will establish sufficient attractive force for the armature of the relay of given figure to close the contacts. Determine the required current to establish this flux level if we assume that t ...

A mixer is used in a short-wave super heterodyne receiver

A mixer is used in a short-wave super heterodyne receiver. The receiver is designed to receive transmitted signals between 5 and 25 MHz. High-side tuning is to be used. Determine the tuning range of the local oscillator ...

Repeat the previous problem and assume the person is 5m

Repeat the previous problem and assume the person is 5m away from the center of the hemisphere. What is the effect of the proximity of the man to the grounding hemisphere?

A determine the transfer function corresponding to the bode

(a) Determine the transfer function corresponding to the Bode plot of the magnitude shown in given figure. (b) What is the actual gain at (i) ω = 50 rad/s, (ii) ω = 150 rad/s, and (iii) ω = 100 krad/s.

The sum of two independent random processes with psdsare

The sum of two independent random processes with PSDs are input to a LTI filter. (a) Determine the Wiener smoothing filter. That is, find the impulse response of the filter that produces an output that is an MMSE estimat ...

Draw the following sheet metal part using cadd software use

Draw the following sheet metal part using CADD software. Use the entry method of your choice. Space is provided in which you can write the coordinate values needed to draw a line to each point-or use a separate sheet.

The open-loop voltage gain of an amplifier is given bya if

The open-loop voltage gain of an amplifier is given by (a) If the low-frequency, closed-loop gain is 100, is this amplifier stable? (b) If so, determine the phase margin.

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

A cola-dispensing machine is set to dispense 9 ounces of

A cola-dispensing machine is set to dispense 9 ounces of cola per cup, with a standard deviation of 1.0 ounce. The manuf

What is marketingbullwhat is marketing think back to your

What is Marketing? • "What is marketing"? Think back to your impressions before you started this class versus how you

Question -your client david smith runs a small it

QUESTION - Your client, David Smith runs a small IT consulting business specialising in computer software and techno

Inspection of a random sample of 22 aircraft showed that 15

Inspection of a random sample of 22 aircraft showed that 15 needed repairs to fix a wiring problem that might compromise

Effective hrmquestionhow can an effective hrm system help

Effective HRM Question How can an effective HRM system help facilitate the achievement of an organization's strate