Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Mechanical Engineering Expert

Linear equations and outputs

An AC sine wave is applied to the input of a full wave rectifier. The output of the full wave rectifier is then applied to a half wave rectifier. The output of the half wave rectifier will most closely resemble:

A) the original sine wave.
B) an inverted form of the original sine wave.
C) the output of the full wave rectifier.
D) none of the above.

A project that will cost $750,000 will require payments as certain milestones are met. The initial payment is $50,000. When 30% of the work is complete an additional payment of $200,000 is due. When 70% of the work is complete another payment of $300,000 is due. Upon completion of the project the balance is due. The closest linear equation to approximate the payment schedule (where Y = amount paid in thousands of dollars, and X = % complete) is:

A) 750 X - Y = 0
B) 750 X - Y = - 50
C) 600 X -Y = -100
D) B = 0

Approximately where would the curve, log Y = log 2X plotted on standard graph paper intercept the Y-axis?

A) 0
B) 0.3
C) 1.0
D) 2.3

An electrical circuit consists of a set of three parallel resistors (A, B, and C) which are connected in series with another set of two parallel resistors, (D, and E). These two sets of resistors are connected in a series loop to a battery. Assume the following resistor values:

A = 33 ohms
B= 100 ohms
C = 51 ohms
D = 22 ohms
E = 10 ohms

How much current could a 12 V battery drive through the circuit?

A) less than 12 ohms
B) greater than 1 amp
C) less than 0.5 amps
D) none of the above

An object is thrown horizontally from the top of a building from an elevation of 64 feet above ground level. The velocity of the object is 56 miles per hour. How far, horizontally will the ball travel before reaching the ground?

A) Less than 170 feet.
B) Less than 160 feet.
C) Each of the above.
D) None of the above.

A football player runs at a speed of 16 feet per second. How long will it take him to run ten yards directly downfield if his course is in a forward direction at an angle of 45 degrees toward the sideline?

A) Less than 2 seconds.
B) More than three seconds.
C) Cannot be determined from the information provided.
D) None of the above.

Mechanical Engineering, Engineering

  • Category:- Mechanical Engineering
  • Reference No.:- M9417503

Have any Question?


Related Questions in Mechanical Engineering

Expansion processes of a perfect gasassignment1 attend the

Expansion Processes of a Perfect Gas Assignment: 1. Attend the laboratory class and complete the lab tests according to the supervisor's requirement. Students will not allowed to submit their report if they do not come t ...

Life cycle assessmentfor your chosen service eg white board

LIFE CYCLE ASSESSMENT For your chosen service (e.g. white board markers), identify two alternatives of getting the service (e.g. brand A, brand B). Choose the most environmentally friendly option by conducting life cycle ...

Problem on shaft -assuming no frictional losses a torque of

Problem on Shaft - Assuming no frictional losses, a torque of T = 750lb·in is applied through the shaft of gear F in order to drive the roller chain at point B at a constant speed. The chain sprocket has a pitch diameter ...

Fluid mechanics assignment - viscous flow in pipesq1 as

Fluid Mechanics Assignment - Viscous Flow in Pipes Q1. As shown in the figure below, water "bubbles up" 3 in. above the exit of the vertical pipe attached to three horizontal pipe segments. The total length of the 0.75-i ...

5star questions amp answers1a define heat treatment bname

5 STAR QUESTIONS & Answers 1. A) Define Heat treatment B) Name different types of heat treatment processes C) Write any 4 purposes of Heat treatment 2. Explain various Heat treatment processes 3. A) Compare Thermo plasti ...

Life cycle assessmentfor your chosen service eg white

LIFE CYCLE ASSESSMENT For your chosen service (e.g. white board markers), identify two alternatives of getting the service (e.g. brand A, brand B). Choose the most environmentally friendly option by conducting life cycle ...

Problem -a long pipe od 1413 mm id 1318 mm kp 20 wmk

Problem - A long pipe (OD = 141.3 mm, ID =131.8 mm, k p = 20 W/m.K) supplies hot pressurized liquid water at 400 K to a heater in a factory. The pipe has an insulation thickness of 100 mm. A new efficient heater replaces ...

Mechanical engineering assignment task - solve the given

Mechanical Engineering Assignment Task - Solve the given problem. Task 1 - A spring with a one-turn loop of 40mm mean radius is formed from a round section of wire having 5 mm diameter. The straight tangential legs of th ...

Assignment - machine learning for signal processingproblem

Assignment - Machine Learning for Signal Processing Problem 1: Instantaneous Source Separation 1. As you might have noticed from my long hair, I've got a rock spirit. However, for this homework I dabbled to compose a pie ...

Question - truss structureconsider the three membered

Question - Truss Structure Consider the three membered planar truss structure shown in the figure below. All members of the truss have identical square cross-sectional area (A) of 25 mm x 25 mm, and Youngs Modulus (E) = ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As