+61-413 786 465
info@mywordsolution.com
Home >> Electrical & Electronics
A half-wave SCR converter circuit is used to regulate the power across a 10Ω resistance. When the triggering angle is 30°, the power consumed by the load is 500W. Compute the rms voltage of the source, and the average and rms currents of the load.
Electrical & Electronics, Engineering
Question - (i) A star-connected, three-phase synchronous induction motor takes a current of 10 amps from a 415 volt supply at unity power factor when supplying a steady load. If the synchronous reactance is 5 ohms/phase ...
Question 1. A pnp transistor with β = 60 is connected in a common-base configuration as shown in figure P5.8 (a) The emitter is driven by a constant-current source with I E = 0.75 mA. Determine I B , I C , α, and V C . ( ...
CASE STUDY This assignment consists of a written report of approximately 1000 words and any diagrams in which you are asked to critically compare different process methods used to achieve the same result and show an awar ...
Questions - Problem 1 - A series RLC network has R = 2 kΩ, L = 40 mH and C = 1μF. Calculate the impedance at resonance and at one-fourth, one-half, twice, and four times the resonant frequency. Problem 2 - Design a serie ...
Assignment - Consider a common emitter amplifier: Now let's say that R B and R C do a fine job at DC biasing the BJT but they are large so they can be neglected for small signal (AC) analysis. In that case, the equivalen ...
Questions - Problem 1 - Solve for i 0 in Fig. using mesh analysis. Problem 2 - Use mesh analysis to find current i 0 in the circuit. Problem 3 - Use mesh analysis to find v 0 in the circuit. Let v s1 = 120 cos(100t+ 90 o ...
1 Goal In this project you will solve a non-trivial design problem explicitly using the divide-and-conquer (D&C) approach. The main reason for using the D&C approach is the ease of the design process and the streamlined ...
1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...
Summative Assessment In 2017 SEJ101 assessment will consist of nine tasks that will develop a portfolio of your assessed work. Throughout the trimester you will have the opportunity for feedback on all nine tasks before ...
Problem # 1: Given a sequence x(n) for 0≤n≤3, where x(0) = 1, x(1) = 1, x(2) = -1, and x(3) = 0, compute its DFT X(k). (Use DFT formula, don't use MATLAB function) Problem # 2: Use inverse DFT and apply it on the Fourier ...
Start excelling in your Courses, Get help with Assignment Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.
Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate
Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p
Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As
Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int
Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As