1three cylinders from the same mix were tested for strenght, Ask an Expert

Engineering

1.Three cylinders from the same mix were tested for strenght. Cylinders A and B were cast in 4x8 molds while cylinder C was cast in a 6x12 mold. The total loads were as follows; cylinder A= 65,200 lbs., cylinder B= 68,550 lbs., cylinder C= 151,190 lbs. Determine the average P.S.I for this mix?

2.A 6kg diskA has an initial velocity of 20m/s and strikes heaadon diskB that has a mass of 24kg and is originally at rest.

If the collision is perfectly elastic,

Determine the speed of each disk after the collision and the impulse which disk A imparts to disk B.

View complete question

Civil Engineering, Engineering

Category:- Civil Engineering
Reference No.:- M91069372

Have any Question?Write your Review or question?

Related Questions in Civil Engineering

Assignment -ewb design report format - cover page - the as

Assignment - EWB Design Report Format - Cover page - The as EWB project Table of content Introduction about -EWB and CRDT (Cambodian Rural development team) Background about Cambodia - Economic, Weather, People - living ...

Assessment taskpractical investigationinstructions- it is

Assessment Task Practical Investigation Instructions: - It is very important that you read these instructions. - The hardcopy of the Assignment report, with the Assignment cover sheet, should be submitted to the Assignme ...

Task details the client is doing masters in civil

Task Details: The client is doing Masters in Civil Engineering. He needs a Technical Paper on Earthquake pertaining to Geology and Rock Mechanics. There should be a through discussion of Earthquake in relation to the men ...

Aimthis assignment aims to demonstrate the structural

Aim: This assignment aims to demonstrate the structural design requirements of a glazed façade in a multi-storey building. Among other requirements, the glazed façade is required to comply with Australian Standard AS 204 ...

Masonry design assignmentquestion 1 - derivation of seismic

MASONRY DESIGN ASSIGNMENT Question 1 - Derivation of seismic actions on building a) Determine the storey seismic weights (Wi) for each suspended level of the building, hence the seismic weight (Wt) of the entire building ...

Masonry design assignmentquestion 1 - derivation of seismic

Aimthis assignment aims to demonstrate the structural

Assignmenta continuous three spans beam with

Assignment A continuous three spans beam with centre-to-centre distance of 6 m supports 150 mm thick one-way slabs as shown below. The beams have clear spans of 8 m, 9 m, and 8 (face-to-face of 400 mm square columns). Th ...

The drainage system of a cantilever wall shown in below

The drainage system of a cantilever wall shown in below figure, became blocked after a heavy rainstorm and the groundwater level, which was originallybelow the base, rose to1.5 (m) below the surface. Determine the stabil ...

Civilyou are provided with bill of quantities prepared

Civil You are provided with bill of quantities prepared separately, priced and submitted by 3 con- tractors (A,B,C found on LMS) in respect of a proposed project (see appendix for drawings). The site is located on Mt. Al ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Civil Engineering Expert

Engineering

Related Questions in Civil Engineering

Assignment -ewb design report format - cover page - the as

Assessment taskpractical investigationinstructions- it is

Task details the client is doing masters in civil

Aimthis assignment aims to demonstrate the structural

Masonry design assignmentquestion 1 - derivation of seismic

Masonry design assignmentquestion 1 - derivation of seismic

Aimthis assignment aims to demonstrate the structural

Assignmenta continuous three spans beam with

The drainage system of a cantilever wall shown in below

Civilyou are provided with bill of quantities prepared

Ask Experts for help!!

Looking for Assignment Help?

Why might a bank avoid the use of interest rate swaps even

Describe the difference between zero coupon bonds and

Compute the present value of an annuity of 880 per year

Compute the present value of an 1150 payment made in ten

Compute the present value of an annuity of 699 per year

Follow Us