Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Electrical & Electronics Expert

1. Electrical conductivity of insulators is the range _____________.

(a) 10-10(?-mm)-1 (b) 10-10(?-cm)-1 (c) 10-10(?-m)-1 (d) 10-8(?-m)-1

2. Units for electric field strength

(a) A/cm2 (b) mho/meter (c) cm2/V.s (d) V/cm

3. Energy band gap size for semiconductors is in the range ________ eV.

(a)1-2 (b) 2-3 (c) 3-4 (d) > 4

4. Energy band gap size for insulators is in the range ________ eV.

(a)1-2 (b) 2-3 (c) 3-4 (d) > 4

5. Flow of electrons is affected by the following

(a) Thermal vibrations (b) Impurity atoms (c) Crystal defects (d) all

6. Not a super conductive metallic element

(a) Fe (b) Al (c) Ti (d) W

7. Fermi energy level for intrinsic semiconductors lies

(a) At middle of the band gap (b) Close to conduction band

(c) Close to valence band (d) None

8. Fermi energy level for p-type extrinsic semiconductors lies

(a) At middle of the band gap (b) Close to conduction band

(c) Close to valence band (d) None

9. Fermi energy level for n-type extrinsic semiconductors lies

(a) At middle of the band gap (b) Close to conduction band

(c) Close to valence band (d) None

10. Not an example for intrinsic semiconductor

(a) Si (b) Al (c) Ge (d) Sn

11. In intrinsic semiconductors, number of electrons __________ number of holes.

(a) Equal (b) Greater than (c) Less than (d) Can not define

12. In n-type semiconductors, number of holes __________ number of electrons.

(a) Equal (b) Greater than (c) Less than (d) Can not define

13. In p-type semiconductors, number of holes __________ number of electrons.

(a) Equal (b) Greater than (c) Less than (d) Twice

14. Mobility of holes is ___________ mobility of electrons in intrinsic semiconductors.

(a) Equal (b) Greater than (c) Less than (d) Can not define

15. Fermi level for extrinsic semiconductor depends on

(a) Donor element (b) Impurity concentration (c) Temperature (d) All

16. Value of dielectric constant for a material __________.

(a) Equal to 1 (b) Greater than 1 (c) Less than 1 (d) Zero.

17. High dielectric constant material is must for __________.

(a) Insulation of wires (b) Generators (c) Switch bases (d) Generators.

18. Dielectric constant for most polymers lies in the range of _______.

(a) 1-3 (b) 2-5 (c) 4-7 (d) 6-10.

19. Example for piezo-electric material

(a) Rochelle salt (b) Lead zirconate (c) Potassium niobate (d) Barium Titanium oxide

20. Example for ferro-electric material

(a) Potassium niobate (b) Lead titanate (c) Lead zirconate (d) quartz

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M92507845
  • Price:- $20

Priced at Now at $20, Verified Solution

Have any Question?


Related Questions in Electrical & Electronics

Problem 1given a sequence xn for 0lenle3 where x0 1 x1 1

Problem # 1: Given a sequence x(n) for 0≤n≤3, where x(0) = 1, x(1) = 1, x(2) = -1, and x(3) = 0, compute its DFT X(k). (Use DFT formula, don't use MATLAB function) Problem # 2: Use inverse DFT and apply it on the Fourier ...

Questions -problem 1 - given the sinuosidal voltage vt 50

Questions - Problem 1 - Given the sinuosidal voltage v(t) = 50 cos(30t+10 o ) V, find: (a) the amplitude V m (b) the period T, (c) the frequency f and (d) v(t) at t = 10 ms. Problem 2 - A current source in a linear circu ...

1 a name the three major groups of contamination and

1. (a) Name the three major groups of contamination and briefly describe their physical characteristics. (b) Where do the above contamination types come from? Give one example of each. 2. Name two processes metrics which ...

Assignment - power distribution system transformerscomplete

Assignment - Power Distribution System Transformers Complete your calculations, drawings, and answers, neatly handwritten on these sheets and hand in at the start of lecture in week 6. Absolutely no late submissions will ...

Question -i a star-connected three-phase synchronous

Question - (i) A star-connected, three-phase synchronous induction motor takes a current of 10 amps from a 415 volt supply at unity power factor when supplying a steady load. If the synchronous reactance is 5 ohms/phase ...

Question 1for the ce amplifier in figure 1 given the

Question 1 For the CE amplifier in Figure (1), given the following component parameters: Parameter Value β DC , β AC 150 V BE 0 . 7 V V CC 12 V R C 820 ? R E 1 100 ? R E 2 220 ? R 1 20 k? R 2 5 . 2 k? R L 100 k? C 1 , C ...

Problem 1 a two-phase servomotor has rated voltage applied

Problem 1: A two-phase servomotor has rated voltage applied to its excitation winding. The torque speed characteristic of the motor with Vc = 220 V, 60 Hz applied to its control phase winding is shown in Fig.1. The momen ...

1 goalin this project you will solve a non-trivial design

1 Goal In this project you will solve a non-trivial design problem explicitly using the divide-and-conquer (D&C) approach. The main reason for using the D&C approach is the ease of the design process and the streamlined ...

A four-pole star-connected squirrel-cage induction motor

A four-pole, star-connected, squirrel-cage induction motor operates from a variable voltage 50 Hz three-phase supply. The following results were obtained as the supply voltage was gradually reduced with the motor running ...

Assignment -problem 1 -a consider the simplified dc system

Assignment - Problem 1 - a) Consider the simplified dc system shown in Fig. 1. Only one converter is modeled, with the remote end represented by a dc source. The ac system is rated at 345 kV, with the converter transform ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As