Ask Question, Ask an Expert

+61-413 786 465

info@mywordsolution.com

Ask Mechanical Engineering Expert

1. A) Calculate the heat loss rate at -10 F outside temperature, 70 F inside, assuming NO internal heat generation, i.e. shutdown at night.

B) Calculate the outside "balance temperature" when the building is fully lighted and occupied with 200 customers and employees.

C) The building is open and in operation 12 hours each day, and is shut down and essentially unoccupied for 12 hours each day, during the cold night time hours. Assume that there are 4000 deg.-F days of heating during these night-time hours. What is the annual heating bill (night-time) if natural gas is used (90% efficiency), costing $7 per 1000 cubic feet (approx. $7 per million Btu)?

D) Assume that you can cool the building adequately with outside air, if the outside air is below 15 C (59 F). Above that temperature, it is necessary to turn on the vapor-compression air cooling, which has a coefficient of performance of 4.00.

Estimate the electrical bill to provide the necessary air conditioning (air cooling) for a year. Assume that there are an average of 100 customers and employees in the store during the day, and that all the lights are on while the store is open for business, 12 hours per day. No A.c. is needed when the building is shutdown at night.

E) What is the total electrical bill for a year, lights, plus air condition, plus ventilating fans (to provide the required 15 cfm per person in the building? (The ventilation fans will use about 2.5 kW of electricity, and will only be needed during the 12 hours each day that the store is open.)

2. A movie theater owner is concerned about complying with ASHRAE standard #62 on air quality. It is a theater complex, each theater having a capacity of 200 people. Thus the ventilating fans need to be designed for nominally 3000 cfm, of fresh air. (Note, these could be variable speed fans, so the speed can be adjusted to the number of occupants, but let's assume these are constant 3000 cfm. )

A typical movie is two hours long, and has 100 patrons, each paying $6. If the outside temperature is 20 F, how much is it costing to heat this fresh air for the two hours? (The natural gas heat is costing $8 per mission Btu.)What fraction is this of the gross receipts?

3. Is a south facing window cost-effective in a home in Southeast Idaho? Assume no overhang (for sun shielding in the summer).

A) Consider only winter net energy loss or gain (from solar). Do the calculation for October through April, for Pocatello typical weather and solar radiation conditions.

B) Make a rough estimate of what you think the penalty of this window is for air conditioning. In general AC is only needed in July and August, the rest of the year can be handled by ventilation. Assume a COP of 3.0 for the AC system, and electricity cost of 5 cents per kWh.

4. Problems Involving the Psychrometric Chart. Consider a warm summer day in Idaho, dry bulb temperature 90 F, and reported relative humidity of 20%.

A) What is the wet bulb temperature? (This is the temperature your skin feels if there is a reasonable movement of air past the skin.)

B) That night it cools down. Assume that the water vapor content in the air remains constant as the cooling occurs. At what temperature will dew start to form?

5. Making sure your A.C. unit has a drain. A home air conditioner/air handler circulates 1400 cfm. The indoor air is nominally 77 F and 50% relative humidity. The air leaving, after passing over the refrigerant coils, is at 50 F and may be considered saturated. How many gallons of water per hour will drip from these coils?

6. Do the same problem for a warm day in Alabama, 90F and reported relative humidity of 70%.

Mechanical Engineering, Engineering

  • Category:- Mechanical Engineering
  • Reference No.:- M91243410

Have any Question?


Related Questions in Mechanical Engineering

Force exerted by jet on moving cart1 you need to determine

Force Exerted By Jet On Moving cart. 1. You need to determine the velocity of water that comes out from the nozzle of this system. need the equation please formulate the equation. 2. This water will strike a small cart a ...

The aim of the project is to demonstrate certain aspects of

The aim of the project is to demonstrate certain aspects of engineering materials in different applications. The projects will be assessed on the basis of a written Research Report. The report should clearly show what yo ...

The aim of the project is to demonstrate certain aspects of

The aim of the project is to demonstrate certain aspects of engineering materials in different applications. The projects will be assessed on the basis of a written Research Report. The report should clearly show what yo ...

Problem -a long pipe od 1413 mm id 1318 mm kp 20 wmk

Problem - A long pipe (OD = 141.3 mm, ID =131.8 mm, k p = 20 W/m.K) supplies hot pressurized liquid water at 400 K to a heater in a factory. The pipe has an insulation thickness of 100 mm. A new efficient heater replaces ...

Question - truss structureconsider the three membered

Question - Truss Structure Consider the three membered planar truss structure shown in the figure below. All members of the truss have identical square cross-sectional area (A) of 25 mm x 25 mm, and Youngs Modulus (E) = ...

Heat transfer and combustionyou will need graph paper a

HEAT TRANSFER AND COMBUSTION You will need graph paper, a calculator, a copy of Appendix 1 from lesson HTC - 4 - 2 and access to steam tables to answer this TMA. 1. A fuel gas consists of 75% butane (C 4 H 10 ), 10% prop ...

Structural mechanics questions -q1 a 150-lb bucket is

Structural Mechanics Questions - Q1. A 150-lb bucket is suspended from a cable on the wooden frame. Determine the resultant internal loadings on the cross section at D, and at E. Q2. The shaft is supported at its ends by ...

5star questions amp answers1a define heat treatment bname

5 STAR QUESTIONS & Answers 1. A) Define Heat treatment B) Name different types of heat treatment processes C) Write any 4 purposes of Heat treatment 2. Explain various Heat treatment processes 3. A) Compare Thermo plasti ...

Assignment - machine learning for signal processingproblem

Assignment - Machine Learning for Signal Processing Problem 1: Instantaneous Source Separation 1. As you might have noticed from my long hair, I've got a rock spirit. However, for this homework I dabbled to compose a pie ...

Materials behaviour from atoms to bridges assignment -

Materials Behaviour from Atoms to Bridges Assignment - Distributed loads and static equilibrium (Please note: you should show your steps with necessary figures) Q1. Two beam sections are jointed at C and supported at A b ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Why might a bank avoid the use of interest rate swaps even

Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate

Describe the difference between zero coupon bonds and

Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p

Compute the present value of an annuity of 880 per year

Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As

Compute the present value of an 1150 payment made in ten

Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int

Compute the present value of an annuity of 699 per year

Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As