Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

Assignment

In this assignment, you will examine the low-carbon technology which would be most suitable to give heat and power for a domestic building.

- Using information try to discover the main energy demands allocated with a domestic building (e.g. electricity for lighting and appliances, space heating, hot water and so on.)

- With knowledge of the demands in your building examine the technical attributes of the below technology:

- Engine-based combined power and heat, gas consumption.

The assignment hand-in must take the form of a short report in that you must: identify and justify the main building energy demands; illustrate the attributes of the above technology, giving pros and cons (including costs) ;

Details

Assignments must be a maximum of 5-6 pages of text – you can also add in diagrams and photographs if helpful.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M9991

Have any Question? 


Related Questions in Electrical & Electronics

1 can h323 also be used for video2 given the following

1. Can H.323 also be used for video? 2. Given the following message, find the compressed data using run-length coding. AAACCCCCCBCCCCDDDDDAAAABBB 3. Given the following message, find the compressed data using the second ...

1 repeat the previous problem without the assumption that

1. Repeat the previous problem without the assumption that the velocity in the heating section is negligible. The ratio of the flow area of the heating section to the chimney flow area is R. 2. Consider a 4-cm pipe that ...

1 in multimedia communication assume a sender can encode an

1. In multimedia communication, assume a sender can encode an image using only JPEG encoding, but the potential receiver can only decode an image if it is encoded in GIF. Can these two entities exchange multimedia data? ...

1 two point charges each of mass m and charge q are

1. Two point charges each of mass m and charge q are suspended by strings of length l from a common point. Find the value of q for which the angle made by the strings at the common point is 90°. 2. Point charges Q and ar ...

Load flow calculation -in the power network shown below

Load Flow Calculation - In the power network shown below, node 1 is the slack bus, where the nodal voltage is defined as (1.0∠0 o ) pu, nodes 2, 4 and 5 are load buses, and node 3 is a generator bus where the voltage mag ...

1 summarize maxwells equations in integral form discuss the

1. Summarize Maxwell's equations in integral form. Discuss the interdependence of timevarying electric and magnetic fields, with the aid of an example. 2. Which two of the Maxwell's equations are independent?

1 discuss the duality between the radiation fields of a

1. Discuss the duality between the radiation fields of a small circular loop antenna with those of a Hertzian dipole at the center of the loop and aligned with its axis. 2. Compare the radiation resistance and directivit ...

1 what is the significance of a nonzero net right-lateral

1. What is the significance of a nonzero net right-lateral differential of and normal to the z-direction at a point in space? 2. If a pair of E and B at a point satisfies Faraday's law in differential form, does it neces ...

1 briefly discuss the solution of the transmission-line

1. Briefly discuss the solution of the transmission-line matching problem. 2. How is the length of a short-circuited stub for a required input susceptance determined by using the Smith Chart?

1 define standing wave ratio swr what are the standing wave

1. Define standing wave ratio (SWR). What are the standing wave ratios for (a) an infinitely long line, (b) a short-circuited line, (c) an open-circuited line, and (d) a line terminated by its characteristic impedance? 2 ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro

Describe what you learned about the impact of economic

Describe what you learned about the impact of economic, social, and demographic trends affecting the US labor environmen