Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

prepare brief notes on:

problem 1) What do you mean by diathermy?

problem 2) Describe sphygmomanometer with working principle and circuit.

problem 3) What do you mean by muscle potential?

problem 4) How MRI is different from CT scan?

problem 5) State the medical uses of isotopes?

problem 6) Describe the terms : TIDAL volume, LUNG COMPLIANCE.

problem 7) Mention biological hazards of microwaves.

problem 8) List the methods of blood flow measurement.

problem 9) Describe the term neurotransmitters.

problem 10) What do you mean by haemodialysis?

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M98399

Have any Question? 


Related Questions in Electrical & Electronics

Consider a uniform bar with a cross-sectional area a 2

Consider a uniform bar with a cross-sectional area, A = 2 10 -4  m 2 , and a unit length, L = 1 m. The bar shows elastoplastic material behavior, as depicted in the figure. The plastic deformation starts at yield stress ...

A source of strength 15 m2s at the origin is combined with

A source of strength 1:5 m 2 /s at the origin is combined with a uniform stream moving at 9 m/s in the x direction. For the half-body which results, find (a) The stagnation point; (b) The body height as it crosses the y ...

A transmission line of length 2 m having a nonmagnetic

A transmission line of length 2 m having a nonmagnetic perfect dielectric is short-circuited at the far end. A variable-frequency generator is connected at its input and the current drawn is monitored. It is found that t ...

A module with 40 cells has an idealized rectangular i-v

A module with 40 cells has an idealized, rectangular I-V curve with I SC = 4 A and V OC = 20 V. If a single cell has a parallel resistance of 5Ω and negligible series resistance, draw the I-V curve if one cell is complet ...

The device in the schematic diagram below is a viscosity

The device in the schematic diagram below is a viscosity pump. It consists of a rotating drum inside of a stationary case. The case and the drum are concentric. Fluid enters at A, flows through the annulus between the ca ...

1 the dam shown below is 100 m wide determine the magnitude

1. The dam shown below is 100 m wide. Determine the magnitude and location of the force on the inclined surface. 2. The float in a toilet tank is a sphere of radius R and is made of a material with ρ. An upward buoyant f ...

Consider a deformation of a rectangular bar whose deformed

Consider a deformation of a rectangular bar whose deformed geometry is given as x 1 = αX 1 , x 2 = βX 2 , x 3 = βX 3 When the material is an incompressible Mooney-Rivlin hyperelastic material with A 10  = 80 MPa and A 01 ...

A sketch x omega the amplitude spectrum of a signal x t 3

a. Sketch |X (ω)|, the amplitude spectrum of a signal x (t) = 3 cos 6πt + sin 18πt + 2 cos(28 - ∉)πt, where ∉ is a very small number → 0. Determine the minimum sampling rate required to be able to reconstruct x (t) from ...

A communication link at a frequency of 30 mhz uses a

A communication link at a frequency of 30 MHz uses a half-wave dipole for the transmitting antenna and a small loop (directivity equal to 1.5) for the receiving antenna, involving a distance of 100 km. The antennas are o ...

1 for the force field f x2ay find the approximate value of

1. For the force field F = x 2 ay, find the approximate value of the line integral of F from the origin to the point (1, 3, 0) along a straight line path by dividing the path into ten equal segments. 2. For the force fie ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro