You make 10-4 m solutions of naoh and nahco3 and a 10-43 m, Ask an Expert

Academics

You make 10-4 M solutions of NaOH and NaHCO3 and a 10-4.3 M solution of Na2CO3. You use pure distilled water that has been fully degassed.

a. What are the pH and alkalinity of these three solutions immediately after you make them?

b. What are the pH and alkalinity of these three solutions after they are allowed to equilibrate with the atmosphere?

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9872600

Have any Question?Write your Review or question?

Related Questions in Chemistry

While heating your copper sulfur mixture the original

While heating your copper sulfur mixture the original crucible lid fell and was broken. You replace the lid with another one. You used the mass of the original lid in your calculations. However the mass of the second lid ...

The density of air at stp is 129gl if your stoppered

The density of air at STP is 1.29g/L. If your stoppered the250mL flask contains 242mL of water(also the volume of air it would contain), calculate the mass of air in the flask under STP.

Nitro glyerine is an explosive used by the mining industry

Nitro glyerine is an explosive used by the mining industry. It detonates according to the following equation: 4C 3 H 5 N 3 O 9 (l)→ 12CO 2 (g) + 6N 2 (g) +10H 2 O(g) + O 2 (g) What volume is occupied by the gases produce ...

C-14 analysis of the shroud of turin has shown that

C-14 analysis of the Shroud of Turin has shown that approximately 93% of the 14C present in living matter is still present in samples taken from the shroud. Based on this information, what is the approximate age of this ...

An aqueous solution has a normal boiling point of 1020degc

An aqueous solution has a normal boiling point of 102.0°C. What is the freezing point of this solution? For water K b is 0.51°C/ m and K f = 1.86°C/ m.

Use the simulator for the hydrogen atom Use the simulator for the hydrogen atom

Use the simulator for the hydrogen atom (https://phet.colorado.edu/en/simulation/hydrogen-atom) to estimate the energy needed to transfer one mole of electrons from the energy level n = 1 to the level n = 3.

Question 1bonding energyi draw an energy level diagram for

Question 1: Bonding Energy i. Draw an energy level diagram for a single Na ion and Cl ion. ii. Explain what is happening to the energy level between these two ions in terms of the Potential Energy. iii. Which process uti ...

When the concentration of a in areaction was changed from

When the concentration of A in areaction was changed from 1.20 M to 0.600M, the half -lifeincreased from 3-00min to 6.0 min at 250C. Calculate theorder of reaction and the rate constant.

You react 1000 ml of a 101 m hbraq solution with 991 mlof a

You react 100.0 ml of a 1.01 M HBr(aq) solution with 99.1 mlof a 1.05 M KOH(aq) solution. The density of each solution is 1.04g/ml. The heat capacity of the calorimeter is 7.0 J/C. You observea ΔT of 6.3 C. Assume a 4.18 ...

A student prepared a stock solution by dissolving 200 g of

A student prepared a stock solution by dissolving 20.0 g of NaOH in enough water to make 150. mL of solution. She then took 15.0 mL of the stock solution and diluted it with enough water to make 65.0 mL of a final soluti ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert