Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Problem statement: Assume you wish to send a 200 bytes long message from your equipment to a friend's machine via four intermediate nodes. You are needed to use a header size of 5 bytes per packet. You have the option of sending the message as 5 packets, as 10 packets and as 20 packets. Which of these three options minimizes the transmission time? What is the minimum transmission time?

Physics, Academics

  • Category:- Physics
  • Reference No.:- M937988

Have any Question? 


Related Questions in Physics

A heavy string is tied at one end to a movable support and

A heavy string is tied at one end to a movable support and to a light thread at the other end as shown in figure (15-E12). The thread goes over a fixed pulley and supports a weight to produce a tension. The lowest freque ...

Which of the following statements are fundamentally correct

Which of the following statements are fundamentally correct and which ones are fundamentally incorrect if taken at their face value without implied interpretation? Give the physics reasons. (a) Half of the energy levels ...

An environmentalist reports that the depth of the water in

An environmentalist reports that the depth of the water in a new reservoir is approximated by where t is in weeks since the date the reservoir was completed and h is in meters. (a) During what period was the reservoir fi ...

The table gives the position of a particle moving along the

The table gives the position of a particle moving along the x-axis as a function of time in seconds, where x is in meters. What is the average velocity of the particle from t = 0 to t = 4?

A long or thick silicon pn junction diode such as the

A long (or thick) silicon p/n junction diode, such as the numerical example given in the text, is made on a silicon wafer of 1 mm thick so that the series bulk resistances cannot be neglected. Calculate the cutoff freque ...

A a persons blood pressure is measured to be 112 plusmn 5

(a) A person's blood pressure is measured to be 112 ± 5 mm Hg. What is its percent uncertainty? (Note that percent uncertainties should be reported to two significant figures.) WebAssign will check your answer for the co ...

A small can of radius r70cm and height h100cm is suspended

A small can of radius r=7.0cm and height h=10.0cm is suspended by a string in a beaker of water so that it's depth is 15cm below the surface. the can is heavy enough that it would sink if it were not tied to the string.( ...

Lets assume there is a spring between the cars at impact

Let's assume there is a spring between the cars at impact (good assumption since most cars today are made to crumple instead of bounce off). What would the energy of the each mass do to the spring? Where would that energ ...

A person on a swing moves so that the chain is horizontal

A person on a swing moves so that the chain is horizontal at the turning points. Show that the centripetal acceleration of the person at the low point of the arc is exactly 2 g, regardless of the length of the chain. Thi ...

A thin film 10 mm thick coat of fresh paint has just been

A thin film, 1.0 mm thick, coat of fresh paint has just been sprayed over a 1.5 m by 1.5 m square steel body part, which approximates a flat surface. The paint contains benzene as the solvent. The paint surface exerts a ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro