Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Physics Expert

Q1. prepare detail notes on the Hermaphrodite caliper and transfer caliper.

Q2. describe the method of wringing in slip gauges.

Q3. Describe the Vernier micrometer.

Q4. List out some of the various marking tools and prepare their uses.

Q5. prepare down any three properties of materials that are used in the manufacturing of gauges.

Q6. prepare down any four linear measuring instruments and their utilizations.

Q7. Sketch the free Hand sketch of the external micrometer and label its parts.

Q8. Describe the two various systems of marking.

Physics, Academics

  • Category:- Physics
  • Reference No.:- M912274

Have any Question? 


Related Questions in Physics

Ammonia nh3 in air is being absorbed into water within the

Ammonia, NH 3 , in air is being absorbed into water within the enclosed tank shown in the figure below. The liquid and gas phases are both well mixed, and mass transfer occurs only at the exposed gas-liquid interface. Th ...

A life preserver is manufactured to support a

A life preserver is manufactured to support a 76 kgperson with 25 %of his volume out of the water. If the density of the life preserver is 100 kg/m3 and it is completely submerged, what must its volume be? Assume that th ...

There is a three-phase ig of 110 v 60nbsphz 4 poles 1900

There is a three-phase IG of 110 V, 60 Hz, 4 poles, 1900 rpm, Y stator connection, and an equivalent circuit given as R 1 = 0.20 Ω, R 2  = 0.42 Ω, X 1  = 0.15 Ω, and X 2  = 0.43 Ω; R 2  and X 2  refer to the stator. The ...

On may 9 2007 cbs evening news had a 43 point rating

On May 9, 2007, CBS Evening News had a 4.3 point rating. (Ratings measure the number of viewers.) News executives estimated that a 0.1 drop in the ratings for the CBS Evening News corresponds to a $5.5 million drop in re ...

As you run toward a stationary trumpet player at 500 ms you

As you run toward a stationary trumpet player at 5.00 m/s, you hear a tone at a frequency of 530 Hz. Find the frequency you would hear if you stood still. Take 342 m/s for the speed of sound in air.

Answer the question posed in problem again but this time

Answer the question posed in Problem again but this, time give a more detailed and less qualitative or more quantitative but concise (itemized) description of the fundamental reasons. Problem:- What is the single most im ...

A large deep lake which initially had a uniform oxygen

A large deep lake, which initially had a uniform oxygen concentration, has its surface concentration suddenly raised and maintained at a higher concentration level. Assuming the lake water to be static, reduce the genera ...

A solar cell panel is attached to the exterior of an

A solar cell panel is attached to the exterior of an orbiting satellite which can be considered a vacuum. The panel is initially in the shadows. It is suddenly exposed to the sun-light. Describe the transient events that ...

1 what is the input to the recursive filter such that its

1. What is the input to the recursive filter such that its state sequence and the transmission are the same as those of the non-recursive filter? 2. Can you spot the most probable path and the flipped bit?

Diffraction in a single-slit diffraction pattern the

Diffraction. In a single-slit diffraction pattern, the forth-order minimum is 1.5° from the center. What's the slit width if the wavelength is 450 nm? and 650 nm?

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro