Which of the water samples that you tested had the highest, Ask an Expert

Academics

which of the water samples that you tested had the highest calcium concentration? does this correlate with the total dissolved solids results you obtained? which of your water the most pure? was this what you would have predicted before the laboratory session? why or why not?

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9871941

Have any Question?Write your Review or question?

Related Questions in Chemistry

An 18g ice cube initially at -10c is dropped into 120 g of

An 18g ice cube initially at -10C is dropped into 120 g of water initially at 25C. What is the final temperature of the system after all of the ice has melted? Use the data provided in the reference data sheet and assume ...

You will have a 500ml solution of salt water from this you

You will have a 500mL solution of salt water. From this you will take 10.0mL and place it on a balance. You find that the 10.0mL solution has a mass of 12.5 g. What is the density of the 500mL of salt water solution in g ...

A student weighed out 174 grams of sodium hydroxide pellets

A student weighed out 1.74 grams of sodium hydroxide pellets and added them to 48.0 grams of water in a calorimeter. Extrapolating back to the time of mixing yielded a temperature change at the time of mixing equal to 9. ...

A chemist must dilute 374 ml of 808 mum aqueous mercuryi

A chemist must dilute 37.4 mL of 8.08 μM aqueous mercury(I) chloride (Hg2Cl2) solution until the concentration falls to 2.00 μM. He'll do this by adding distilled water to the solution until it reaches a certain final vo ...

What is the volume of a solution in milliliters that

What is the volume of a solution, in milliliters, that contains 1.5 g LiNO3 and has a concentration of 0.40 M?

A student is doing the experiment chemical formulas of

A student is doing the experiment Chemical Formulas of Copper Sulfide by heating copper with excess of sulfur at very high temperatures using a Bunsen burner. Copper and sulfur react stoichiometrically and excess of sulf ...

An aqueous solution has a normal boiling point of 1020degc

An aqueous solution has a normal boiling point of 102.0°C. What is the freezing point of this solution? For water K b is 0.51°C/ m and K f = 1.86°C/ m.

1 potassium hydrogen phthalate is a solid monoprotic acid

1. Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a primary standard. It has the unwieldy formula of KHC 8 H 4 O 4 . This is often written in shorthand notation as KHP. If ...

Do you notice any trends or can you make any

Do you notice any trends or can you make any generalizations about where certain types of liquids fall on the pH scale?

A gas is confined to a cylinder with a moveable piston to

A gas is confined to a cylinder with a moveable piston (to allow the gas to expand or contract) under a pressure of 1 atmosphere. When the temperature of the gas is increased, 850 J of heat is added, and the gas expands, ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert