+61-413 786 465
info@mywordsolution.com
Home >> Chemistry
When 0.204 moles of (NH4)3PO4 in enough water to make 1.00 L of solution, what is the total concentration of all ions present in solution?
Chemistry, Academics
Why does a hydrate exist only as a solid? What characteristic of a hydrate is responsible for this phenomenon?
A Chem major obtains a high-paying summer job and is given the task of determining the ethanol content (in vol %) of a commercial mouthwash sample. she decides to use gas chromatography because the experiment was so much ...
1. A beaker contains a clear, colorless liquid. It has three chemical substances in it, two are liquid and one of them is a solid. How could you determine if it has water, ethanol, and table salt? Remember you're not all ...
A metal slug weighing 16.32g is added to a flask with a volumeof 52.6 mL. it is found that, 40.2 g of methanol (d = 0.791 g/mL)must be added to the metal to fill the flask. What is the density of the metal in g/mL?
1. Suppose 100.0 mL of an aqueous solution containing an unknown monoprotic acid (called HA) is titrated with 0.150 M KOH. The titration requires 47.82 mL of the potassium hydroxide to reach the equivalence point. What i ...
Calculate the boling point of a solution prepared by adding 11.5 g naphthalene (C10H8) to 250.0 g of benzene. Naphthalene is a non-electrolyte solute, and benzene is an organic solvent that exhibits a boiling point of 80 ...
The molecular weight of an unknown gas was measured by an effusion experiment. It was found that it took 64 seconds for the gas to effuse, whereas nitrogen required 48 seconds. The molecular mass of the gas is ?
A student weighed out 1.74 grams of sodium hydroxide pellets and added them to 48.0 grams of water in a calorimeter. Extrapolating back to the time of mixing yielded a temperature change at the time of mixing equal to 9. ...
A power plant converts the heat energy in coal to electricity with 35% efficiency. Transmission losses are 10%. A factory then uses that electricity to make hydrogen with 50% efficiency, which is used in a fuel cell to m ...
At a given pressure and temperature, it takes 198.7 sec for a 2.6 L sample of Kr to effuse through a porous membrane. How long does it take for 2.6 L Ar to effuse under the same conditions?
Start excelling in your Courses, Get help with Assignment Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.
Why might a bank avoid the use of interest rate swaps, even when the institution is exposed to significant interest rate
Describe the difference between zero coupon bonds and coupon bonds. Under what conditions will a coupon bond sell at a p
Compute the present value of an annuity of $ 880 per year for 16 years, given a discount rate of 6 percent per annum. As
Compute the present value of an $1,150 payment made in ten years when the discount rate is 12 percent. (Do not round int
Compute the present value of an annuity of $ 699 per year for 19 years, given a discount rate of 6 percent per annum. As