What is the power output of the turbine? h1 1322.6, Ask an Expert

Academics

Steam at 200 psia and 600 degrees F [state 1] enters a turbine through a 3 inch diameter pipe with a velocity of 10 ft/s. The exhaust from the turbine is carried through a 10 inch diameter pipe and is at 5 psia and 200 degrees F [state 2]. What is the power output of the turbine? H1= 1322.6 Btu/lbm v1=3.058 (ft)^3/lbm H2= 1148.6 Btu/lbm v2=78.14 (ft)^3/lbm

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9441046

Have any Question?Write your Review or question?

Related Questions in Chemistry

A sealed vessel contains a gaseous mixture of h2 and excess

A sealed vessel contains a gaseous mixture of H2 and excess O2. The mixture is at 500 K and has a total pressure of 140 kPa. After all of the hydrogen is reacted, the total pressure of the system measured at the same tem ...

The density of air at stp is 129gl if your stoppered

The density of air at STP is 1.29g/L. If your stoppered the250mL flask contains 242mL of water(also the volume of air it would contain), calculate the mass of air in the flask under STP.

What are the symbol and name of the element whose average

What are the symbol and name of the element whose average atoms have a mass very nearly half the mass of an average silicon atom?

A paint contains 1800 ppm lead approximately what mass of

A paint contains 180.0 ppm lead. Approximately what mass of lead will be in 1.00 cm ^3 of this paint when 1.00 gal is uniformly applied to 445.0 ft 2 of a wall. The density of the paint is 8.00 lb/gal.

Insoluble pbbr2snbspnbspprecipitates when solutions of

Insoluble PbBr2(s) precipitates when solutions of Pb(NO3)2(aq) and NaBr(aq) are mixed. Pb(NO3)2(aq) + 2NaBr(aq) ---> PbBr2(s) + 2NaNO3(aq) ΔrH = ? To measure the enthalpy change, 350. mL of 0.50 M Pb(NO3)2(aq) and 350. ...

A solution of hydrochloric acid has a volume of 250 ml and

A solution of hydrochloric acid has a volume of 250. mL and a pH of 1.92. Exactly 250. mL on 0.0105 M NaOH is added. What is the pH of the resulting solution?

A power plant converts the heat energy in coal to

A power plant converts the heat energy in coal to electricity with 35% efficiency. Transmission losses are 10%. A factory then uses that electricity to make hydrogen with 50% efficiency, which is used in a fuel cell to m ...

Name five types of radiation describe in table form their

Name five types of radiation. Describe, in table form, their mass number, charge, and identity.

Suppose that you take 5000 gram of na2co3 and titrate it

Suppose that you take .5000 gram of Na2CO3 and titrate it with .115M HCL solution. What is the equivalence point volume expected for the complete titration? (Formula weights Na2CO3 = 105.99g/mol and HCL = 36.46g/mol)

A chemist adds 1900 ml of a 2810-6 moll mercuryi chloride

A chemist adds 190.0 mL of a 2.8*10^-6 mol/L mercury(I) chloride (Hg2Cl2) solution to reaction flask. Calculate the micromoles of mercury(I) chloride the chemist has added to the flask. Round your answer to 2 significant ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert