What is the maximum pressure that will be attained in the, Ask an Expert

Academics

A gas is placed in a storage tank at a pressure of 20.0 atm at 20.3 DEGREES CELSIUS. As a safety device, there is a small metal plug in the tank made of a metal alloy that melts at 125 DEGREES CELSIUS. If the tank is heated, what is the maximum pressure that will be attained in the tank before the plug will melt and release gas?

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9453387

Have any Question?Write your Review or question?

Related Questions in Chemistry

Why do the instructions call for using a saturated solution

Why do the instructions call for using a saturated solution of NaOH rather than one at lower concentration? Why can we ignored in the calculation of the concentration of NaOH?

An iron skillet weighing 128kg is heated on a stove to

An iron skillet weighing 1.28kg is heated on a stove to 178°C. Suppose the skillet is cooled to room temperature., 21°C. How much heat energyin joules must be removed to effect this cooling? The specific heat of iron is ...

This experiment involves collecting data for the cooling of

This experiment involves collecting data for the cooling of water between 175 o -160. o F in different containers. What is 175 o F in celsius? Please report your answer correctly to three significant digits.

When 514g of biphenyl c12h10 undergoes combustion in a bomb

When .514g of biphenyl (C12H10) undergoes combustion in a bomb calorimeter, the temperature rises from 25.8 degrees C to 29.4 degrees C. Find delta E(rxn) for the combustion of biphenylin kJ/mol. The heat capacity of the ...

While heating your copper sulfur mixture the original

While heating your copper sulfur mixture the original crucible lid fell and was broken. You replace the lid with another one. You used the mass of the original lid in your calculations. However the mass of the second lid ...

Consider the following questionsa what is the total volume

Consider the following questions: (a) What is the total volume of the CO2(g) and H2O(g) at 600 °C and 0.888 atm produced by the combustion of 1.00L of 2H6(g) measured at STP? (b) What is the partial pressure of H2O in th ...

An 18g ice cube initially at -10c is dropped into 120 g of

An 18g ice cube initially at -10C is dropped into 120 g of water initially at 25C. What is the final temperature of the system after all of the ice has melted? Use the data provided in the reference data sheet and assume ...

Use the simulator for the hydrogen atom Use the simulator for the hydrogen atom

Use the simulator for the hydrogen atom (https://phet.colorado.edu/en/simulation/hydrogen-atom) to estimate the energy needed to transfer one mole of electrons from the energy level n = 1 to the level n = 3.

At a given pressure and temperature it takes 1987 sec for a

At a given pressure and temperature, it takes 198.7 sec for a 2.6 L sample of Kr to effuse through a porous membrane. How long does it take for 2.6 L Ar to effuse under the same conditions?

1 consider the reaction when aqueous solutions

1. Consider the reaction when aqueous solutions of nickel(II) bromide and sodium carbonate are combined. The net ionic equation for this reaction is: 2. Net ionic equation for the reaction that occurs when aqueous so ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert