Ask Question, Ask an Expert

+1-415-315-9853

info@mywordsolution.com

Ask Electrical & Electronics Expert

problem 1: Illustrate the differences between salient pole and non salient pole synchronous machine.

problem 2: Derive the emf equation of alternator; describe the coil span factor, distribution factor and derive the expressions?

problem 3: A 3-phase, 8-pole, 750 rpm star – connected alternator has 72 slots on the armature. Each slot has 12 conductors and winding is short chorded by 2 slots. Find out the induced emf between lines, given the flux per pole is 0.06 wb.

problem 4:

a) What are the benefits and drawbacks of using short – pitched winding and distributed winding in alternator?
b) Derive the expression of coil span factor and distribution factor.

problem 5:

a) Describe the constructional details of synchronous machine.
b) Where salient pole rotors are favored.

problem 6: Compute the distribution factor for a 36-slot, 4-pole single layer 3-phase winding.

Electrical & Electronics, Engineering

  • Category:- Electrical & Electronics
  • Reference No.:- M93627
  • Price:- $70

Priced at Now at $70, Verified Solution

Have any Question? 


Related Questions in Electrical & Electronics

1 a determine the transfer function vosv1 s for the circuit

1. (a) Determine the transfer function Vo(s)/V1 (s) for the circuit shown below. (b) From the transfer function identify what type of filter it is. (c) Justify your answer of part b 2. (a) Draw the circuit of a free runn ...

The mass m of drops formed by liquid discharging by gravity

The mass M of drops formed by liquid discharging by gravity from a vertical tube is a function of the tube diameter D, liquid density, surface tension, and the acceleration of gravity. Determine the independent dimension ...

1 discuss how the cutoff condition arises in a waveguide2

1. Discuss how the cutoff condition arises in a waveguide. 2. Explain the relationship between the cutoff wavelength and the spacing between the plates of a parallel-plate waveguide based on the phenomenon at cutoff.

The trigonometric fourier series of a certain periodic

The trigonometric Fourier series of a certain periodic signal is given by a. Sketch the exponential Fourier spectra. b. By inspection of the spectra in part (a), sketch the trigonometric Fourier spectra for x(t). Find th ...

1 discuss with the aid of an example the discharging of an

1. Discuss with the aid of an example the discharging of an initially charged line into a resistor. 2. Discuss the bounce-diagram technique of transient analysis of a line with uniform initial voltage and current distrib ...

In natural-convection problems the variation of density due

In natural-convection problems, the variation of density due to the temperature difference ?T creates an important buoyancy term in the momentum equation. If a warm gas at T H moves through a gas at temperature T 0 and i ...

A certain communication channel has a bandwidth of 10 khz a

A certain communication channel has a bandwidth of 10 kHz. A pulse of 0.5 ms duration is transmitted over this channel. a. Determine the width (duration) of the received pulse. b. Find the maximum rate at which these pul ...

A the highest frequency in the spectrum x omega fig p81-8a

a. The highest frequency in the spectrum X (ω) (Fig. P8.1-8a) of a bandpass signal x (t) is 30 Hz. Hence, the minimum sampling frequency needed to sample x (t) is 60 Hz. Show the spectrum of the signal sampled at a rate ...

For the euler beam element shown in the figure derive the

For the Euler beam element shown in the figure, derive the interpolation functions, N I (ξ), stiffness matrix, k, and nodal force vector, f. Assume that the uniformly distributed load is  f (x) = f. Note that the referen ...

Let xt be a signal whose fourier transform xomega is

Let x(t) be a signal whose Fourier transform X(ω) is nonzero only over 3 ≤ |ω| ≤ 9. Further, only frequencies 5 ≤ |ω| ≤ 7 contain useful information (the other frequencies can be considered to contain noise or different ...

  • 4,153,160 Questions Asked
  • 13,132 Experts
  • 2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

WalMart Identification of theory and critical discussion

Drawing on the prescribed text and/or relevant academic literature, produce a paper which discusses the nature of group

Section onea in an atwood machine suppose two objects of

SECTION ONE (a) In an Atwood Machine, suppose two objects of unequal mass are hung vertically over a frictionless

Part 1you work in hr for a company that operates a factory

Part 1: You work in HR for a company that operates a factory manufacturing fiberglass. There are several hundred empl

Details on advanced accounting paperthis paper is intended

DETAILS ON ADVANCED ACCOUNTING PAPER This paper is intended for students to apply the theoretical knowledge around ac

Create a provider database and related reports and queries

Create a provider database and related reports and queries to capture contact information for potential PC component pro