Water flowing through pipes of carbon steel must be kept at, Ask an Expert

Academics

Water flowing through pipes of carbon steel must be kept at PH 5 or greater than limit corrosion if an 8.0 *10^3 Ib/hr water stream contains 10 ppm sulfuric acid and 0.015% acetic acid, how many pounds per hour of sodium acetate trihydrate must be added to maintain the PH? assume that the sulfuric acid completely ionizes to SO4^2-

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9856933

Have any Question?Write your Review or question?

Related Questions in Chemistry

Why do the instructions call for using a saturated solution

Why do the instructions call for using a saturated solution of NaOH rather than one at lower concentration? Why can we ignored in the calculation of the concentration of NaOH?

1 a beaker contains a clear colorless liquidnbspit has

1. A beaker contains a clear, colorless liquid. It has three chemical substances in it, two are liquid and one of them is a solid. How could you determine if it has water, ethanol, and table salt? Remember you're not all ...

How many grams of h2so4 must be dissolved into 0709 l of

How many grams of H2SO4 must be dissolved into 0.709 L of solution to generate a concentration of 0.303 M?

What is the mass percent of oxygen in manganese iv

What is the mass percent of oxygen in Manganese (IV) phosphate? How many cubic feet (ft 3 ) are 5.14E+08 gallons (gal) of water? The density of water at ambient conditions is 1.000 g/mL

Calculate the volume in milliliters of a 0616m barium

Calculate the volume in milliliters of a 0.616M barium chlorate solution that contains 475.mmol of barium chlorate (Ba(ClO3)2). Round your answer to 3 significant digits.

Wat is the molarity to the hundredths place of 50 g hpo3

What is the molarity, to the hundredths place, of 5.0 g HPO3 in 300. mL of solution?

A power plant converts the heat energy in coal to

A power plant converts the heat energy in coal to electricity with 35% efficiency. Transmission losses are 10%. A factory then uses that electricity to make hydrogen with 50% efficiency, which is used in a fuel cell to m ...

You react 1000 ml of a 101 m hbraq solution with 991 mlof a

You react 100.0 ml of a 1.01 M HBr(aq) solution with 99.1 mlof a 1.05 M KOH(aq) solution. The density of each solution is 1.04g/ml. The heat capacity of the calorimeter is 7.0 J/C. You observea ΔT of 6.3 C. Assume a 4.18 ...

If 0750 l of argon at 150 atm and177degc and 0235 l of

If 0.750 L of argon at 1.50 atm and177°C and 0.235 L of sulfur dioxide at 95.0 kPa and 63.0°Care added to a 1.00-L flask and the flask's temperature is adjustedto 25.0°C, what is the resulting pressure in the flask?

Sodium sulfide 117 g reacts with hydrochloric acid 167 ml

Sodium sulfide (11.7 g) reacts with hydrochloric acid (16.7 ml, 12.0 M) to yield sodium chloride and hydrogen sulfide. What is the theoretical yield (g) of hydrogen sulfide?

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert