Utilized hexanol rather than hexane as the tlc solvent, Ask an Expert

Academics

Utilized hexanol rather than hexane as the TLC solvent. Explain how might this have affected the TLC results?

a) Movement of mixture components on plate would likely have been reversed.

b) All components of the mixture would probably have high Rf values.

c) All components would probably have low Rf values.

d) It would have no effect.

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M91224873

Have any Question?Write your Review or question?

Related Questions in Chemistry

It takes 378 ml of 02114 m naoh to neutralize 193 ml of an

It takes 37.8 mL of 0.2114 M NaOH to neutralize 19.3 mL of an oxalic acid solution with an unknown concentration. Calculate the actual concentration of this oxalic acid solution. Don't forget to look at the balanced equa ...

Why do the instructions call for using a saturated solution

Why do the instructions call for using a saturated solution of NaOH rather than one at lower concentration? Why can we ignored in the calculation of the concentration of NaOH?

A chem major obtains a high-paying summer job and is given

A Chem major obtains a high-paying summer job and is given the task of determining the ethanol content (in vol %) of a commercial mouthwash sample. she decides to use gas chromatography because the experiment was so much ...

Using data from unfiltered white light and the white light

Using data from unfiltered white light and the white light through the yellow filter, determine which two colors of light mix to form yellow. Support your conclusion with a quantitative discussion of relative peak intens ...

A student takes 50ml of a stock fescn2 solution and dilutes

A student takes 5.0mL of a stock FeSCN2+ solution and dilutes it with deionized water to a volume of 50mL. He then puts the solution in a Spectronic 20 instrument and determines the the % transmittance of the new solutio ...

What would an increase in the metal wire mass indicate when

What would an increase in the metal wire mass indicate when the metal wire starts to form copper on it from a chemical reaction from 6M HCl and copper (II) sulfate pentahydrate? What would a decrease in the metal wire ma ...

A 1000 g sample of copper metal is heated in a crucible and

A 1.000 g sample of copper metal is heated in a crucible and after 15 minutes themass of the crucible contents is 1.111 g. Calculate the mass of copper (II) oxide that was produced.

Protein folding assignmentin an in vitro protein folding

PROTEIN FOLDING ASSIGNMENT In an "in vitro" protein folding experiment monitored by fluorescence measurements the following data was obtained for protein X: [GuHCl], M Wavelength Maxima, nm 0 330 0.5 332 1.0 331 1.5 332 ...

1 consider the reaction when aqueous solutions

1. Consider the reaction when aqueous solutions of nickel(II) bromide and sodium carbonate are combined. The net ionic equation for this reaction is: 2. Net ionic equation for the reaction that occurs when aqueous so ...

The atomic masses of lithium-6 759 and lithium-7 9241 are

The atomic masses of Lithium-6 (7.59%) and Lithium-7 (92.41%) are 6.0151 and 7.016 amu, respectively. Calculate the average atomic mass of chlorine. The percentages in parentheses denote the relative abundances.

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert