The reduction potential of agaq to ags is 080 v and the, Ask an Expert

Academics

The reduction potential of Ag^+|(aq) to Ag(s) is +0.80 V, and the reduction potential of Cu^2+ (aq) to Cu (s) is + 0.34 V. A galvanic cell is based on the following reaction:
2 Ag^+ (aq) + Cu (s) -----> 2 Ag (s) + Cu^2+ (aq)

The silver compartment contains a silver electrode and excess AgCl(s) (Ksp = 1.6 x 10^-10) which gives a silver ion concentration of 1.27 x 10^-5 M. The copper compartment contains a copper electrode and [Cu^2+] = 2.0 M.

a) Claculate the potential for this cell, Ecell, at 25 degree Celsius.

b) Can a reaction be spontaneous at 298 K when its delta Grxn (298 K) is positive?

Explain.

c) A reaction taking place under standard conditions is sponteneous at 1000 K but is nonsponteneous at 300 k. What are the signs of delta Hrxn and delta S rxn?

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M91041732

Have any Question?Write your Review or question?

Related Questions in Chemistry

A paint contains 1800 ppm lead approximately what mass of

A paint contains 180.0 ppm lead. Approximately what mass of lead will be in 1.00 cm ^3 of this paint when 1.00 gal is uniformly applied to 445.0 ft 2 of a wall. The density of the paint is 8.00 lb/gal.

What is the mass percent of oxygen in manganese iv

What is the mass percent of oxygen in Manganese (IV) phosphate? How many cubic feet (ft 3 ) are 5.14E+08 gallons (gal) of water? The density of water at ambient conditions is 1.000 g/mL

While heating your copper sulfur mixture the original

While heating your copper sulfur mixture the original crucible lid fell and was broken. You replace the lid with another one. You used the mass of the original lid in your calculations. However the mass of the second lid ...

A power plant converts the heat energy in coal to

A power plant converts the heat energy in coal to electricity with 35% efficiency. Transmission losses are 10%. A factory then uses that electricity to make hydrogen with 50% efficiency, which is used in a fuel cell to m ...

A metal slug weighing 1632g is added to a flask with a

A metal slug weighing 16.32g is added to a flask with a volumeof 52.6 mL. it is found that, 40.2 g of methanol (d = 0.791 g/mL)must be added to the metal to fill the flask. What is the density of the metal in g/mL?

The heat fusion of pure silicon is 434 kjmol how much

The heat fusion of pure silicon is 43.4 kJ/mol. How much energy would be needed to melt a 5.24 - g sample of silicon at its melting point of 1693 K?

Wat is the molarity to the hundredths place of 50 g hpo3

What is the molarity, to the hundredths place, of 5.0 g HPO3 in 300. mL of solution?

Calculate the volume of 60m naoh solution that you would

Calculate the volume of 6.0M NaOH solution that you would need to prepare 500mL of a .15M NaOH solution. (formula weight of NaOH = 40.00g/m)

How is vacuum filtration completing the purification of

How is vacuum filtration completing the purification of your sample? Where are the impurities at this point? For a recrystallization lab in organic chemistry

Asolution is prepared by dissolving 2244 grams of acetic

Asolution is prepared by dissolving 22.44 grams of acetic acid inenough water to make250.0 mL of solution. A 25.00-mL aliquot of NaOH solution is thentitrated with the acetic acid solution. 37.28 mL of the acetic acid so ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert