That the reaction was endothermic. if the enthalpy of, Ask an Expert

Academics

Energy is either absorbed or released for all chemical reactions, and we call this energy the enthalpy of reaction (?Hrxn). If the enthalpy of reaction is positive, then we say that the energy was absorbed or that the reaction was endothermic. If the enthalpy of reaction is negative, then we say that energy was released or that the reaction was exothermic. Most chemical reactions are exothermic. In this problem, you will measure the amount of heat released when solid MgO is reacted with aqueous HCl to form water and then you will calculate the heat of reaction. MgO(s) + 2HCl(aq) = H2O(l) + MgCl2(aq) A weigh paper will be on the balance with approximately 2.81 g MgO on the paper. The calorimeter will be on the lab bench and filled with 100 mL 1.000 M HCl. Data Table: Mass MgO 2.8045g initial temperature(°C) 24.99°C final temperature(°C) 25.00 °C Is the observed reaction endothermic or exothermic? What will be the sign of ?Hrxn?

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9449191

Have any Question?Write your Review or question?

Related Questions in Chemistry

A compound contains only carbon hydrogen and oxygen

A compound contains only carbon, hydrogen, and oxygen. Combustion of 10.68 mg of the compound yields 15.48 mg CO2 and 7.39 mg H2O. The molar mass of the compound is 182.2 g/mol. What are the empirical and molecular formu ...

If you carry out the reaction between table salt nacl and

If you carry out the reaction between table salt (NaCl) and copper(II) sulfate (CuSO4) in 100.0 mL of water, the salt copper(II) sulfate will behave similarly to the salts given in the tab named Slightly Soluble Salts. E ...

A student weighed out 174 grams of sodium hydroxide pellets

A student weighed out 1.74 grams of sodium hydroxide pellets andadded them to 48.0 grams of water in a calorimeter. Extrapolatingback to the time of mixing yielded a temperature change at the timeof mixing equal to 9.20 ...

In the spring time a background ozone level of 290 ppbv was

In the spring time, a background ozone level of 29.0 ppbv was measured in Edmonton. Convert the mixing ratio of 29.0 ppbv ozone to units of molecules cm-3. Assume a pressure of 1.108 atm and a temperature of 12.5 ºC.

0394 mol of a solid was dissolved in 340 ml of water at 269

0.394 mol of a solid was dissolved in 340 mL of water at 26.9 oC. After the solid had fully dissolved, the final temperature of the solution was 31.6 oC. What is the molar heat of solution of the substance?

You react 1000 ml of a 101 m hbraq solution with 991 mlof a

You react 100.0 ml of a 1.01 M HBr(aq) solution with 99.1 mlof a 1.05 M KOH(aq) solution. The density of each solution is 1.04g/ml. The heat capacity of the calorimeter is 7.0 J/C. You observea ΔT of 6.3 C. Assume a 4.18 ...

Why do the instructions call for using a saturated solution

Why do the instructions call for using a saturated solution of NaOH rather than one at lower concentration? Why can we ignored in the calculation of the concentration of NaOH?

Suppose 17 g of zinc is treated with 62 g of pure hydrogen

Suppose 1.7 g of zinc is treated with 6.2 g of pure hydrogen chloride. What is the maximum mass (in g) of hydrogen gas that can be produced?

What is the chemical name for s6o and what is the chemical

What is the chemical name for S6O and what is the chemical name for S7O2?

An aqueous solution has a normal boiling point of 1020degc

An aqueous solution has a normal boiling point of 102.0°C. What is the freezing point of this solution? For water K b is 0.51°C/ m and K f = 1.86°C/ m.

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert