Suppose that an enzyme has the capacity to conver substrate, Ask an Expert

Academics

Suppose that an enzyme has the capacity to conver substrate A (Km= 1 x 10^-3 M) to a product P1. Suppose the same enzyme can also convert another substrate B (Km = 1 x 10^-6 M) to a different product, P2. ALso suppose that an equal Vmax is possible with both of the substrates. Which substrate will show a greater rate of rection at 1 x 10^-3 M? Which substrate will show a greater rate at 1 x 10^-2 M? What will be the effect of addition of B on the rate of reaction with A?

View complete question

Chemistry, Academics

Category:- Chemistry
Reference No.:- M9864188

Have any Question?Write your Review or question?

Related Questions in Chemistry

What is the calculation of the new temperature of a gas

What is the calculation of the new temperature of a gas sample has an original volume of 740 ml when collected at 710 mm and 35 o C when the volume becomes 460 ml at 1.20 atm?

Suppose a tank is filled with a2g so that initial pressure

Suppose a tank is filled with A2(g) so that initial pressure is 0.8688 atm at temperature of 298K. Some of the A2(g) dissociates and when the system reaches equlibrium the total pressure in the tank is 1.275 atm. Calcula ...

A 200 ml sample of 0200 m hbr solution is titratedwith 0200

A 20.0 mL sample of 0.200 M HBr solution is titratedwith 0.200 M NaOH solution. Calculate the pH of the solution after the following volumes of base have been added. (19.8 mL)

An iron skillet weighing 128kg is heated on a stove to

An iron skillet weighing 1.28kg is heated on a stove to 178°C. Suppose the skillet is cooled to room temperature., 21°C. How much heat energyin joules must be removed to effect this cooling? The specific heat of iron is ...

Use the simulator for the hydrogen atom Use the simulator for the hydrogen atom

Use the simulator for the hydrogen atom (https://phet.colorado.edu/en/simulation/hydrogen-atom) to estimate the energy needed to transfer one mole of electrons from the energy level n = 1 to the level n = 3.

A sample consisting of 10 mol caco3s was heated to 800 degc

A sample consisting of 1.0 mol CaCO3(s) was heated to 800 °C, when it decomposed. The heating was carried out in a container fitted with a piston that was initially resting on the solid. Calculate the work done during co ...

A chemist must preparenbsp725 ml ofnbsp275 mm aqueous

A chemist must prepare 725. mL of 275. mM aqueous copper(II) sulfate CuSO4 working solution. He'll do this by pouring out some 0.316 M aqueous copper(II) sulfate stock solution into a graduated cylinder and diluting it w ...

Using data from unfiltered white light and the white light

Using data from unfiltered white light and the white light through the yellow filter, determine which two colors of light mix to form yellow. Support your conclusion with a quantitative discussion of relative peak intens ...

Explain why the mass of the crucible and anhydrous salt is

Explain why the mass of the crucible and anhydrous salt is less than the mass of the crucible and the hydrate. What is the chemical formula of copper (II) sulfate?

Determine if the reactants shown on the right would result

Determine if the reactants shown on the right would result in the formation of a precipitate. Choices can be used more than one time or not at all. Forms a precipitate Will not form a precipitate Na 2 SO 4 + Ba(NO 3 ) 2 ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Chemistry Expert