Solve the following question given belowquestion a brass, Ask an Expert

Academics

Solve the following question given below:

Question: A brass rod is 69.5 cm long and an aluminum rod is 49.3 cm long when both rods are at an initial temperature of 0°C. The rods are placed in line with a gap of 1.2 cm between them, as shown in the figure. The distance between the far ends of the rods is maintained at 120.0 cm throughout. The temperature of both rods is raised equally until they are barely in contact. The coefficients of linear expansion of brass and aluminum are 2.0 × 10^-5 (brass) and 2.4 × 10^-5 (aluminum) in SI units.

Part A- At what temperature does contact occur?

Show all work, use additional paper if necessary.

View complete question

Physics, Academics

Category:- Physics
Reference No.:- M91232378

Have any Question?Write your Review or question?

Related Questions in Physics

Question seat belts and air bags save lives by reducing the

Question: Seat belts and air bags save lives by reducing the forces exerted on the driver and passengers in an automobile collision. Cars are designed with a "crumple zone" in the front of the car. In the event of an imp ...

Question the potential energy u of an object of mass m that

Question: The potential energy U of an object of mass m that is separated by a distance R from an object of mass M is given by U = -GMm/R A. What is the kinetic energy K of the satellite? Express your answer in terms of ...

Question a semicircle of radius a is in the first and

Question: A semicircle of radius a is in the first and second quadrants, with the center of curvature at the origin. Positive charge +Q is distributed uniformly around the left half of the semicircle, and negative charge ...

1 evaluate 50000 107380 10-16 report 2 decimals for

1) Evaluate (5.0000 * 10^7)(3.80 * 10^-16). Report 2 decimals for result 2) 1,400 kg car moving at 7.0 m/s is stopped by action of it braces. The work done by the car braces is .....Joules. Response in 2 decimals. 3) The ...

A 0900 kg hammer is moving horizontally at 950 ms when it

A 0.900 kg hammer is moving horizontally at 9.50 m/s when it strikes a nail and comes to rest after driving it 1.00 cm into a board. Calculate the duration of the impact. (s) What was the average force exerted on the nai ...

Question a plastic rod that has been charged to -15 nc

Question: A plastic rod that has been charged to -15 nC touches a metalsphere. Afterward, the rod's charge is -10 nC. a. What kind of charged particle was transferred between the rodand the sphere, and in which direction ...

Quesiton you stand at the top of a deep well to determine

Quesiton: You stand at the top of a deep well. To determine the depth (D) of the well you drop a rock from the top of the well and listen for the splash as the water hits the waterâ€ TM s surface. The splash arrives t = ...

Question a projectile is fired with an initial speed of

Question: A projectile is fired with an initial speed of 30m/s at an angle of60 deg above the horizontal. The object hits the ground 7.5slater. a) How much higher or lower is the launch point relative to thepoint where t ...

Question some passengers on an ocean cruise may suffer from

Question: Some passengers on an ocean cruise may suffer from motion sickness as the ship rocks back and forth on the waves. At one position on the ship, passengers experience a vertical motion of amplitude 1.6m with a pe ...

A hiker measures the angle of elevation to the top of a

A hiker measures the angle of elevation to the top of a cliff as 16.0o. She walks 1.20 km further away from the cliff on level ground, she finds the angle to be 11.0 o. a) Draw a diagram of the problem - you may ignore t ...

4,153,160 Questions Asked
13,132 Experts
2,558,936 Questions Answered

Ask Experts for help!!

Looking for Assignment Help?

Start excelling in your Courses, Get help with Assignment

Write us your full requirement for evaluation and you will receive response within 20 minutes turnaround time.

Ask Now Help with Problems, Get a Best Answer

Recent Questions

Ask Physics Expert